Dynamical research on spherical micro actuator with PZT drivers

CHEN Hai-chu

doi:null

您当前的位置：

首页 >

文章列表页 >

Dynamical research on spherical micro actuator with PZT drivers

更新时间：2020-08-12

- Dynamical research on spherical micro actuator with PZT drivers
- Optics and Precision Engineering Vol. 15, Issue 2, Pages: 248-253(2007)
- 作者机构：
  
  浙江大学流体传动及控制国家重点实验室,浙江杭州,310027
- 作者简介：
- 基金信息：
- DOI：
  CLC： TP242.2
- Received：21 November 2006，
  
  Revised：19 December 2006，
  
  Published Online：20 February 2007，
  
  Published：20 February 2007
- 稿件说明：
移动端阅览
CHEN Hai-chu. Dynamical research on spherical micro actuator with PZT drivers[J]. Optics and precision engineering, 2007, 15(2): 248-253.
DOI：

CHEN Hai-chu. Dynamical research on spherical micro actuator with PZT drivers[J]. Optics and precision engineering, 2007, 15(2): 248-253. DOI：

摘要

研制出了尺寸为30 mm×30 mm×50 mm的压电陶瓷驱动的球基微驱动器样机

并对该微驱动器进行动力学分析以及微型轴孔装配的实验研究。建立了微驱动器金属球空间坐标关系

分析了球基微驱动器的动力学特征

并建立了其动力学模型。采用龙格-库塔法计算出了微驱动器的动力学参数

并利用MATLAB的SIMULINK模块搭建了微驱动器的仿真模型

并对其进行了动力学仿真分析。研制出了球基微驱动器样机

并在此基础上

集成微夹持器形成微操作器

对微驱动器性能进行了实验测试

并开展了Φ180 μm微型轴与Φ200 μm微型孔之间的精密微装配实验研究。最后

分析了微驱动器金属球质量、驱动信号频率、以及金属球与微驱动单元摩擦块接触表面摩擦系数对其性能的影响。实验结果表明:该球基微驱动器的转动分辨率为0.000 1°

转动定位精度为0.000 5°

微驱动器最大工作频率为1 200 Hz。实验结果验证了逆转振动模型的正确性

由该微驱动器所集成的微操作器

完全可以满足对微小元器件的微米级操作与装配等精密作业的要求。

Abstract

A 30 mm×30 mm×50 mm spherical micro actuator driven by piezoelectric ceramic stacks (PZT) was developed

and the dynamics of the spherical micro actuator was analyzed

the micro assembly between micro shaft and micro spindle sleeve by the micro actuator was researched. First

this paper set up a space coordinate relationship of the spherical micro actuator to analyze dynamical characteristics. Following that

it used the Runge-Kutta arithmetic to calculate the dynamical parameters of the micro actuator and to built a dynamical model to simulate it by the SIMULINK module of MATLAB. After these

a spherical micro actuator experimental sample was developed

and a micromanipulator with a micro-gripper based on the sample spherical micro actuator was integrated

By the micro assembly experimental research between a micro shaft of Φ180 μm and a micro spindle sleeve of Φ200 μm

the characteristics of the spherical micro actuator impacted by the metal sphere mass of the micro actuator

driving signal frequency

friction coefficient of the contact surface between the metal sphere and the friction block of the micro driving unit were analyzed. The experimental results indicate that the rotate resolution

the rotate positioning precision and the maximum working frequency of the micro actuator are 0.000 1°

0.000 5° and 1 200 Hz

respectively. The experimental results validate the back rotation and vibration model of the spherical micro actuator

it shows that the micromanipulator integrated by the spherical micro actuator can meet requires of precise micro operation and assembly for MEMS or other microelements in micron fields.

关键词

Keywords

references

. 王会香, 陈立国, 孙立宁. 生物显微切割微操作仪的设计与研制[J]. 光学精密工程,2006,14(3): 416-421. WANG H X, CHEN L G, SUN L N. Design of micromanipulation instrument for bio-microdissection [J]. Opt. Precision Eng., 2006, 14(3): 416-421. (in Chinese)

. 刘国君, 程光明, 杨志刚. 一种压电式精密输液微泵的试验研究[J]. 光学精密工程,2006,14(4): 612-616. LIU G J, CHENG G M, YANG ZH G. Experimental research on a piezoelectric micro-pump for precision pumping [J]. Opt. Precision Eng., 2006, 14(4): 612-616. (in Chinese)

. BREGUET J M, CLAVEL R. Stick and slip actuators: design, control, performances and applications . International Symposium on Micromechatronics and Human Science, Nagoya, Japan, 1998: 89-95.

. FUCHIWAKI O, AOYAMA H. Design and control of versatile micro robot for microscopic manipulation [J]. Am. Soc. Precision Eng., 2001: 204-207.

. SUN L N, CHEN H C, LI M T. 3D.O.F. ball base microactuator with piezoelectric tube drivers . 3rd International Symposium on Instrumentation Science and Technology, Xi'an, China, 2004: 1007-1011.

. 孙立宁,陈海初,李满天,等. 基于惯性-摩擦驱动的球基微驱动器的逆转现象分析[J]. 摩擦学学报,2005,25(5):480-483. SUN L N, CHEN H CH, LI M T, et al.. Analysis of the back rotation phenomenon in ball base microactuators based on the inertia-friction driving principle [J]. Tribology, 2005, 25(5): 480-483. (in Chinese)

. SUN L N, CHEN H CH, LI M T. Dynamics analysis of microactuator with PZT drivers based on inertia-friction driving principle . Proceedings of the 2005 IEEE International Conference on Mechatronics, Taipei, Taiwan, 2005: 334-339.

. 王姝歆, 陈国平, 周建华. 复合型柔性铰链机构特性及其应用研究[J]. 光学精密工程,2005,13(增): 91-97. WANG SH X, CHEN G P, ZHOU J H. Compliant mechanisms consisted of compound flexible hinges and its applications[J]. Opt. Precision Eng., 2005, 13(supp.): 91-97. (in Chinese)

. 孙立宁, 孙绍云, 曲东升, 等. 基于PZT的微驱动系统及控制方法的研究[J]. 光学精密工程,2004,12(2): 55-59. SUN L N, SUN SH Y, QU D SH, et al.. Micro drive positioning system based on PZT and its control [J]. Opt.Precision Eng., 2004, 12(2): 55-59. (in Chinese)

. 陈海初. 宏/微驱动精密作业微小型移动机器人的研究 . 哈尔滨工业大学,2005. CHEN H CH. Research on macro/micro driven miniature mobile robot for precision manipulation . Harbin Institute of Technology, 2005. (in Chinese).

Views

661

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Kinematics and dynamics of 2UU-PSU upper limb rehabilitation mechanism

Development of micro assembly system for friction resistance sensor manufactured based on MEMS

Inverse dynamics modeling of 3-RPS/3n-SPS parallel mechanism with redundant limbs

Electromagnet door release mechanism in deploying mechanism for CubeSats

Inverse dynamic modeling and control of spatial rigid-flexible parallel manipulator

Related Author

GUI Xiaogeng

CUI Bingyan

LI Wenjing

AN Fuxin

SHANG Lin

WU Weiying

DU Yilun

Liguo CHEN

Related Institution

Huadian Heavy Industries Co.，LTD.

College of Mechanical Engineering， North China University of Science and Technology

Hypervelocity Aerodynamics Institute， China Aerodynamics Research and Development Center

School of Mechanical and Electrical Engineering， Soochow University

School of Mechanical Engineering, Yan Shan University

AI问答

Address：No.3888 Dong Nanhu Road, Changchun, Jilin, China Postal code：130033
Tel：0431-86176855 Email：gxjmgc@ciomp.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 吉ICP备11002662号-17 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰