LIN Xu-dong, CHEN Tao, WANG Jian-li, WANG Fu-guo. Active optics figure control of segmented mirror[J]. Editorial Office of Optics and Precision Engineering, 2009,17(1): 98-103
LIN Xu-dong, CHEN Tao, WANG Jian-li, WANG Fu-guo. Active optics figure control of segmented mirror[J]. Editorial Office of Optics and Precision Engineering, 2009,17(1): 98-103DOI:
To realize the active control of each segment of a segmented telescope
the figure control equation of hexagonal mirrors was built up
and the impact of sensor location on figure control system was studied. A working manner of the active control system based on the measurement requirements of relative segment locations was confirmed. Then
a figure control system consisting of 3 segments was built up
and the influence of the sensor location on figure control was analyzed.And also
a sensor setting scheme in which sensor is perpendicularly away in centimeters was put forward. Finally
the applicability of this scheme to the extent of segmented mirrors was testified. The analysis results indicate that the change of location between the mirrors can be exactly measured in fixed two sensors with 0.02 m stagger along the same gap when the segment mirror has side length of 0.9 m and diagonal length of 1.8 m
also the control system can give out the correct adjusted information of actuators. These conclutions reported here show that proposed scheme can satisfy the requirements of real time and high precise control of the active figure of the segmented mirror.
关键词
Keywords
references
MAST T S, NELSON J E. Figure control for a fully segmented telescope mirror [J]. Appl. Opt.,1982,21(14):2631–2641.[2] 苏定强,崔向群. 主动光学——新一代大型望远镜的关键技术[J]. 天文学进展,1999,17(1):1-14. SU D Q, CUI X Q. Active optics——the key technology for new generation big aperture telescopes [J]. Progress in Astronomy. 1999, 17(1): 1-14.(in Chinese)[3] MINOR R H,ARTHUR A A,GABOR G,et al.. Displacement sensors for the primary mirror of the W.M. Keck telescope .SPIE,1990,1236,Advanced Technology Optical Telescopes Ⅳ:1009-1017.[4] 邹维曜.大型拼接镜面望远镜的面形控制 . 南京:天文光学技术研究所,1996. ZOU W Y. Figure control of big segmented mirror telescope . Nanjing:Nanjing Institute of Astronomical Optics and Technology,1996. (in Chinese)[5] 程景全.天文望远镜原理和设计[M]. 北京:中国科学技术出版社,2003. CHENG J Q. Principle and Design of Astronomical Telescope [M].Beijing: China Science & Technology Press, 2003.[6] 杨德华,戚永军,朱振东,等. 光学拼接镜面微位移主动调节机构的设计和实测[J]. 光学 精密工程,2005,13(2):191-197. YANG D H, QI Y J, ZHU ZH D, et, al.. Design and test of the active micro-motion mechanism for optical mirror segment [J]. Opt. Precision Eng., 2005, 13(2): 191-197. (in Chinese)[7] 刘建芳,杨树臣,杨志刚,等. 新型压电精密步进旋转驱动器研究[J]. 光学 精密工程,2006,14(4):594-601. LIU J F, YANG SH CH, YANG ZH G,et al.. Study on precision PZT rotary step actuator with inner anchor/loosen [J].Opt. Precision Eng., 2006, 14(4): 594-601.(in Chinese)