WANG Wei, LIN Yu-chi, ZHU Ping-yu. Application of FBG sensor to measurement of dynamic performance of low impedance material[J]. Editorial Office of Optics and Precision Engineering, 2009,17(3): 488-492
WANG Wei, LIN Yu-chi, ZHU Ping-yu. Application of FBG sensor to measurement of dynamic performance of low impedance material[J]. Editorial Office of Optics and Precision Engineering, 2009,17(3): 488-492DOI:
Application of FBG sensor to measurement of dynamic performance of low impedance material
The application of Fiber Bragg Grating(FBG) sensor to measurement of material property is researched. The principle of Split Hopkinson Pressure Bar (SHPB) for dynamic performance measurement of low impedance material is introduced and the problems related to the application of FBG sensor in SHPB for strain testing are discussed. The relation between the strain wave propagating in elastic bar of low impedance material and the wavelength shift is derived. Then
the interrogation system for high frequency dynamic strain measurement based on FBG is set up and the surface strain of elastic bar in SHPB is measured with the interrogation system and compared with the instrument PI02-04.The experimental results show that the interrogation system has good performance during 10 kHz and its signal-to-noise is about 40 dB.Research results prove that FBG sensor has a good application prospect in the dynamic performance measurement of low impedance material.
关键词
Keywords
references
李丽,林玉池,付鲁华,等. 光纤光栅空分光复用传感系统的研究[J]. 光学 精密工程,2007,15(4):473-477. LI L,LIN Y CH, FU L H, et al..Research on spatial division multiplexing of fiber Bragg grating sensors[J].Opt. Precision Eng.,2007,15(4):473-477.(in Chinese)[2] TSUDA H.Ultrasound and damage detection in CFRP using fiber Bragg grating sensors[J].Composites Science and Technology,2006(66):676-683.[3] LEE J R,TSUDA H, TOYAMA N.Impact wave and damage detections using a strain-free fiber Bragg grating ultrasonic receiver[J].NDT&E International,2007(40):85-93.[4] KOSLSKY Y H. An investigation of the mechanical properties of materials at very high rates of loading[J].Proc Phys. Soc. London, 1949(62):676-700.[5] LO Y,SIRKIS S J.Passive signal processing of in-line fiber etalon sensors for high strain-rate loading[J].Journal of Lightwave Technology,1997,15(8):1578-1586.[6] 刘德顺,朱萍玉,彭佑多,等. 冲击载荷下弹性杆端的作用-位移关系曲线的一点应变测试法[J]. 湘潭矿业学院学报,2000,15(2):18-22. LIU D SH, ZHU P Y, PENG Y D,et al..A method for determination of dynamic force-displacement curve from one-point strain measurement on an elastic rod endface[J].Journal of Xiangtan Mining Institute,2000,15(2):18-22.(in Chinese)[7] MOREY A W, MELTZ G, GLENN W. Fiber optic Bragg grating sensors . Fiber Optic Lasers Sensors VII, 1989,1169:98-107.[8] KERSEY A D,BERKOFF T A,MOREY W.High-resolution fiber-grating based strain sensor with interferometric wavelength-shift detection[J]. Electron Lett., 1992,28(3):236-238.[9] DANDRIDGE A,TVETEN A,GIALLORENZI T.Homodyne demodulation scheme for fiber optical sensors using phase generated carrier[J].IEEE.Journal of Quantum Electronics,1982,18(10):1647-1655.