STOCK J M, SIEGMUND O H W, HULL J S, et al.. Cross delay line microchannel plate detectors for the spectrographic imager on the IMAGE satellite[J]. SPIE, 1998, 3445: 407-414.[2] MENDE S B, HEETDERKS H,FREY H U. Far ultraviolet imaging from the IMAGE spacecraft.1.system design[J]. Space Science Reviews, 2000,91: 243-270.[3] MENDE S B,HEETDERKS H,FREY H U. Far ultraviolet imaging from the IMAGE spacecraft.2. wideband FUV imaging[J]. Space Sci. Rev.,2000,91: 271-285.[4] 赵宝升,王俊峰,邹玮. 球面微通道板及其制备方法: 中国,ZL 200410073378.0 . 2005. ZHAO B SH, WANG J F, ZOU W. The preparation of the spherically curve microchannel plate: China, No. ZL 200410073378.0 .2005.(in Chinese)[5] 尼启良,李敏,饭鲜红,等. 微通道板在12~40 nm波段的量子效率测量[J]. 光学 精密工程,2008,16(1):1-5. NI Q L,LI M,FAN X H, et al.. Quantum efficiency of microchannel plate in 12-40 nm[J].Opt.Precision Eng.,2008,16(1):1-5.(in Chinese)[6] 李敏,尼启良,董宁宁, 极紫外波段微通道板光电子产出理论分析与实验测量[J]. 光谱学与光谱分析,2010,30(8):2030-2034. LI M, NI Q L,DONG N N. Theoretical analysis and experimental measurement for secondary electron yield of microchannel plate in extreme ultravilolet region[J]. Spectroscopy and Spectral Analysis, 2010,30(8):2030-2034.(in Chinese)[7] HENKE B L, KNAUER J P, PREMARATNE K.The characterization of X-ray photocathodes in the 0.1-10-keV photon energy region[J].Appl.Phys., 1981,52(3):1509-1530.[8] FRASER G W.The electron detection efficiency of microchannel plates[J].Nucl. Instrum. Methodes Phys.Res.,1983,206(3):445-449.[9] 尼启良,齐立红,陈波, 使用气体靶激光等离子体光源的软X射线反射率计[J]. 光学 精密工程,2004,12(6):576-580. NI Q L,QI L H,CHEN B. Soft X-ray reflectometer based on laser-produced plasma source with a gas-jet target[J].Opt.Precision Eng., 2004, 12(6): 576-580. (in Chinese)[10] 曹继红, 一种软X射线/极紫外波段标定方法研究 . 长春:中国科学院长春光学精密机械与物理研究所,2003. CAO J H.Study of calibrating method in soft X-ray/EUV .Changchun:Changchun Institute of Optics, Fine Mechnics and Physics,Chinese Academy of Sciences, 2003. (in Chinese)[11] 曹继红,尼启良,陈波, 用Si光电二极管标定软X射线探测器[J]. 光学精密工程,2004,12(1):118-121. CAO J H,NI Q L,CHEN B.Calibration of soft X-ray detector[J].Opt.Precision Eng., 2004,12(1):118-121.(in Chinese)