Calibration of transition matrix on cubic prisms in mapping camera and star sensor

WANG Zhi; WU Guo-dong

doi:10.3788/OPE.20122001.0096

您当前的位置：

首页 >

文章列表页 >

Calibration of transition matrix on cubic prisms in mapping camera and star sensor

Article | 更新时间：2020-08-12

- Calibration of transition matrix on cubic prisms in mapping camera and star sensor
- Optics and Precision Engineering Vol. 20, Issue 1, Pages: 96-101(2012)
- 作者机构：
  
  中国科学院长春光学精密机械与物理研究所,吉林长春,中国,130033
- 作者简介：
- 基金信息：
- DOI：10.3788/OPE.20122001.0096
  CLC： V447.3;V448.222
- Received：18 March 2011，
  
  Revised：01 April 2011，
  
  Published Online：25 January 2012，
  
  Published：25 January 2012
- 稿件说明：
移动端阅览
王智, 吴国栋. 测绘相机立方镜与星敏立方镜转换矩阵的标定[J]. 光学精密工程, 2012,20(1): 96-101

WANG Zhi, WU Guo-dong. Calibration of transition matrix on cubic prisms in mapping camera and star sensor[J]. Editorial Office of Optics and Precision Engineering, 2012,20(1): 96-101
王智, 吴国栋. 测绘相机立方镜与星敏立方镜转换矩阵的标定[J]. 光学精密工程, 2012,20(1): 96-101 DOI： 10.3788/OPE.20122001.0096.

WANG Zhi, WU Guo-dong. Calibration of transition matrix on cubic prisms in mapping camera and star sensor[J]. Editorial Office of Optics and Precision Engineering, 2012,20(1): 96-101 DOI： 10.3788/OPE.20122001.0096.

摘要

传输型立体测绘卫星利用测绘相机进行摄影测量时

需要确定测绘相机在惯性坐标系中的姿态。确定姿态时

首先由星敏感器测量得到星敏测量坐标系在惯性坐标系中的姿态

然后通过星敏测量坐标系与星敏立方镜的转换矩阵、星敏立方镜与测绘相机立方镜的转换矩阵

得到测绘相机测量坐标系在惯性坐标系中的姿态。文中介绍了各坐标系的定义

根据星敏立方镜与测绘相机立方镜坐标系的关系

利用4台经纬仪测量系统分别建立星敏立方镜和测绘相机立方镜的坐标系以及2坐标系间的转换矩阵

介绍了2个立方镜坐标系的标定方法

多次测量结果表明

最大标定误差为1.011 6"

优于2"(1)

满足立体测绘精度的要求。

Abstract

It is necessary to determine camera postures in inertial coordinate systems

when the mapping camera is used in a photogrammetry for a transport stereo mapping satellite. In determining the camera postures

the postures of star sensor measuring system in the inertial coordinate system were measured by star sensors

then

the postures of the mapping camera measuring system in the inertial coordinate system were obtained by the transition matrix between star sensor measuring system and the cubic prism in star sensor and the transition matrix between the two cubic prisms in the star sensor and mapping camera. This paper introduces the definition of coordinate systems. By using the measuring systems of four theodolites

we establish coordinate systems on two cubic prisms respectively and a transition matrix for the coordinate systems. The calibration method of two coordinate systems is presented. The measuring results from many experiments show that the maximum calibration error is 1.011 6

which is better than 2(1) and satisfies the precision requirement of the stereoscopic mapping.

关键词

Keywords

references

王智,张立平,姚惠. 三线阵立体测绘相机光学镜头的设计 [J].光子学报,2010,39(2):227-232. WANG Z, ZHANG L P, YAO H. Design on optical lens of three-linear tridimensional mapping camera[J]. Acta Photonica Sinica, 2010,39(2):227-232. (in Chinese)[2] 王智,乔克,张立平. 三线阵立体测绘卫星LMCCD相机的实现 [J].光机电信息,2010,27(11):110-114. WANG Z, QIAO K, ZHANG L P. Implementation of LMCCD camera for stereo mapping satellite using three-line array CCDs[J]. OME Information, 2010,27(11):110-114. (in Chinese)[3] 陈元枝. 基于星敏感器的卫星三轴姿态测量方法研究 .长春:中国科学院长春光学精密机械与物理研究所,2000. CHEN Y ZH. Method for testing satellitic axes attitude based on star tracker . Changchun:Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences,2000. (in Chinese)[4] 陈东祥,王多,王金敏. 利用"球面三角"建立三维图形旋转变换参数间的关系 [J].工程图形学学报,2001,4(4):97-99. CHEN D X, WANG D, WANG J M. Applying spherical trigonometry method to establish the interconversion between 3D rotation transformation parameters[J]. Journal of Engineering Graphics, 2001,4(4):97-99. (in Chinese)[5] 吴国栋,宋丹. 测绘相机坐标系与立方镜转换矩阵的标定 [J].光学精密工程,2007,15(11):1727-1730. WU G D, SONG D. Calibration of mapping camera and cubic prism coordinate system[J]. Opt. Precision Eng., 2007,15(11):1727-1730. (in Chinese)[6] 宋丹. 星载测绘系统中星、地相机综合几何标定精度分析 .北京:中国科学院研究生院,2008. SONG D. Accuracy analysis of mapping camera comprehensive geometric calibration in the spaceborne mapping system . Beijing: Graduate University of Chinese Academy of Sciences,2008. (in Chinese)[7] 吴国栋. 离轴三反光学镜头像面畸变的标定方法 [J].光学精密工程,2008,16(11):2127-2131. WU G D. Calibration of distortion for three-mirror off-axis[J]. Opt. Precision Eng.,2008,16(11):2127-2131. (in Chinese)

Views

307

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Calibration of mapping camera and cubic prism coordinate system

Calibration of installation angle for high accuracy shipboard star sensor

Calibration of sun sensor and cubic prism coordinate system

Astronomical calibration method and observation analysis for high-accuracy star sensor

Parameter calibration of laser tracking attitude measurement system based on multi-position targets

Related Author

WU Guo-dong

SONG Dan

GUO Jing-ming

ZHAO Jin-yu

HE Xin

LIU Bing

ZHANG Tong-shuang

Pan Liang

Related Institution

Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences, Changchun 130033, China

Graduate School of the Chinese Academy of Sciences, Beijing 100039, China

China Satellite Maritime Tracking and Controlling Department, Jiangyin

北京航空航天大学

National Astronomical Observatory,Chinese Academy of Sciences

AI问答

Address：No.3888 Dong Nanhu Road, Changchun, Jilin, China Postal code：130033
Tel：0431-86176855 Email：gxjmgc@ciomp.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 吉ICP备11002662号-17 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰