Mounted dynamic characteristics of washer type piezoelectric six-axis force sensors

doi:10.3788/OPE.20152313.0279

您当前的位置：

首页 >

文章列表页 >

Mounted dynamic characteristics of washer type piezoelectric six-axis force sensors

更新时间：2020-08-13

- Mounted dynamic characteristics of washer type piezoelectric six-axis force sensors
- Optics and Precision Engineering Vol. 23, Issue 10z, Pages: 279-285(2015)
- 作者机构：
  
  重庆大学光电技术及系统教育部重点实验室重庆,400044
- 作者简介：
- 基金信息：
- DOI：10.3788/OPE.20152313.0279
  CLC： TP212.12
- Received：20 March 2015，
  
  Revised：27 April 2015，
  
  Published：14 November 2015
- 稿件说明：
移动端阅览
刘俊, 杜晶晶, 吕华溢. 垫圈式压电六维力传感器的安装动态特性[J]. 光学精密工程, 2015,23(10z): 279-285

LIU Jun, DU Jing-jing, L&#220 etc. Mounted dynamic characteristics of washer type piezoelectric six-axis force sensors[J]. Editorial Office of Optics and Precision Engineering, 2015,23(10z): 279-285
刘俊, 杜晶晶, 吕华溢. 垫圈式压电六维力传感器的安装动态特性[J]. 光学精密工程, 2015,23(10z): 279-285 DOI： 10.3788/OPE.20152313.0279.

LIU Jun, DU Jing-jing, L&#220 etc. Mounted dynamic characteristics of washer type piezoelectric six-axis force sensors[J]. Editorial Office of Optics and Precision Engineering, 2015,23(10z): 279-285 DOI： 10.3788/OPE.20152313.0279.

摘要

为了研究垫圈式压电六维力传感器在实际测量过程中的动态特性

开展了传感器安装动态特性仿真方法和实验标定方法研究。根据垫圈式压电六维力传感的工作原理及结构特点

分析了传感器动态特性的研究方法。按照带预紧安装的垫圈式压电六维力传感器实验原型参数建立了数值模型

开展了数值仿真方法和传感器动态特性仿真。最后

对垫圈式压电六维力传感器的安装固有频率进行了标定及实验研究。实验结果表明:垫圈式压电六维力传感器各维度上的安装固有频率大于3.9 kHz

且数值仿真方法和实验标定方法得到的标定结果一致。垫圈式压电六维力传感器的安装固有频率优于现有技术

提出的仿真方法和标定方法可用于此类传感器安装固有频率的预估和标定。

Abstract

To research dynamic characteristics of a washer type piezoelectric six-axis force sensor in a practical measurement

simulation method and calibration method of the mounted dynamic characteristics were presented. According to the working principle and the structural characteristics of the washer type piezoelectric six-axis force sensor

the research methods for mounted dynamic characteristics of the sensor were analyzed. Then

in accordance with experiment prototype parameters of the pre-stressed washer type piezoelectric six-axis force sensor

its numerical model was established

and the numerical simulation method and mounted dynamic characteristics were investigated. Finally

the dynamic calibration method for mounted resonance frequency of the sensor was developed. Experimental results indicate that the mounted resonance frequency of washer type piezoelectric six-axis force sensor is more than 3.9 kHz

and the results of the numerical simulation method are consistent with calibration results. The mounted resonance frequency of the sensor is superior to that of the available technology. The proposed simulation and calibration methods can be used in the prediction and calibration of the mounted resonance frequency of this kinds of sensors.

关键词

Keywords

references

王栋,余陵,武晓松. 火箭发动机六分力试验系统力学和误差特性[J]. 弹道学报,2009,21(3):23-25,47. WANG D, YU L, WU X S. Mechanical and error characteristics of rocket engine thrust vector test system[J]. Journal of Ballistics,2009,21(3):23-25,47.(in Chinese)

彭超,史玉杰. XX型火箭助飞鱼雷雷箭分离高速风洞试验测力天平研制[J]. 实验流体力学,2006,20(2):82-84,96. PENG CH,SHI Y J. Balance development of XX torpedo using the rocket boosting in the separation test of the torpedo and the rocket in high speed wind tunnel[J]. Journal of Experiments in Fluid Mechanics,2006,20(2):82-84,96.(in Chinese)

王春洁,曾福明. 弹射座椅动态舒适性与人椅动力学特性研究[J]. 北京航空航天大学学报, 2004,30(4):375-378. WANG CH J,ZENG F M. Research of human-seat dynamics model and ejection seat dynamic comfort[J]. Journal of Beijing University of Aeronautics and Astronautics, 2004,30(4):375-378.(in Chinese)

WEN Y CH,KENNETH J W. Wrench reconstruction by using a six-axis force sensor[J]. Mech. Mach. Theory., 1995, 30(3):383-389.

姚建涛,孙锟,李立建,等. 整体预紧式六维力传感器动态特性分析[J]. 仪器仪表学报, 2014,35(5):1037-1043. YAO J T, SUN K, LI L J, et al.. Dynamic characteristic analysis of pre stressed washer type Stewart structure six-axis force sensor[J]. Chinese Journal of Scientific Instrument, 2014, 35(5):1037-1043.(in Chinese)

PARK Y K, KUMME R, KANG D I. Dynamic investigation of a binocular six-component force-moment sensor[J]. Measurement Science and Technology, 2002, 13(8):1311-1318.

XU K J, LI CH, ZHU ZH N. Dynamic modeling and compensation of robot six-axis wrist force/torque sensor[J]. IEEE Transactions on Instrumentation and Measurement, 2007, 56(5):2094-2100.

LI Y J, WANG G C, ZHANG J, et al.. Dynamic characteristics of piezoelectric six-dimensional heavy force-moment sensor for large-load robotic manipulator[J]. Measurement, 2012, 45(5):1114-1125.

侯雨雷,曾达幸,姚建涛,等. 超静定并联式六维力传感器动力学[J]. 光学精密工程,2009,17(7):1594-1601. HOU Y L, ZENG D X,YAO J T, et al.Dynamics of hyperstatic washer type six component force sensor[J].Opt. Precision Eng., 2011, 33(6):898-905.(in Chinese)

王志军,姚建涛,王航,等. 并联预紧式六维力传感器动态力响应分析[J]. 机器人,2011,33(4):455-460. WANG ZH J, YAO J T, WANG H, et al.Dynamic force response analysis on washer type pre-stressed six-axis force sensor[J].Robot, 2011, 33(4):455-460.(in Chinese)

刘俊,秦岚,李敏,等. 平板式压电六维力/力矩传感器的研制[J]. 光学精密工程, 2011,19(7):1569-1579. LIU J, QIN L, LI M, et al.. Development of parallel piezoelectric six-axis force/torque sensor[J]. Opt. Precision Eng., 2011, 19(7):1569-1579.(in Chinese)

LIU J, LI M, QIN L, et al.. Active design method for the static characteristics of a piezoelectric six axis force torque sensor[J]. Sensors, 2014, 14(1):659-671.

Views

165

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Parameter calibration of laser tracking attitude measurement system based on multi-position targets

Automatic calibration and control system of optical switching delay line

Positioning error compensation of 6-DOF robots based on anisotropic error similarity

Three-dimensional light field endoscope calibration based on light field disparity amplifier and super-resolution network

Hartley eddy current sensor used in maglev molecular pump

Related Author

XIONG Zhi

ZHONG Chenxiaopeng

ZHANG Hao

JIA Xiaodong

GUO Zhengnan

ZHAO Ziyue

ZHAI Zhongsheng

ZHOU Weihu

Related Institution

Institute of Microelectronics， Chinese Academy of Sciences

Changcheng Institute of Metrology & Measurement

Hubei Key Laboratory of Modern Manufacture Quality Engineering， School of Mechanical Engineering， Hubei Wniversity of Technology

Advanced Photonics Center， School of Electronic Science and Engineering， Southeast University

Yunnan International Joint Laboratory of Intelligent Control and Application of Advanced Equipment， Kunming University of Science and Technology

AI问答

Address：No.3888 Dong Nanhu Road, Changchun, Jilin, China Postal code：130033
Tel：0431-86176855 Email：gxjmgc@ciomp.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 吉ICP备11002662号-17 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰