Calculation of overlapping pixels in interleaving assembly for CCD focal plane of space camera

WU Yi-nan; LI Guo-ning; ZHANG Yu

doi:10.3788/OPE.20162402.0422

您当前的位置：

首页 >

文章列表页 >

Calculation of overlapping pixels in interleaving assembly for CCD focal plane of space camera

更新时间：2020-08-13

- Calculation of overlapping pixels in interleaving assembly for CCD focal plane of space camera
- Optics and Precision Engineering Vol. 24, Issue 2, Pages: 422-429(2016)
- 作者机构：
  
  中国科学院长春光学精密机械与物理研究所,吉林长春,中国,130033
- 作者简介：
- 基金信息：
- DOI：10.3788/OPE.20162402.0422
  CLC： V447.3;TN386.5
- Received：17 April 2015，
  
  Revised：25 June 2015，
  
  Published：25 February 2016
- 稿件说明：
移动端阅览
武奕楠, 李国宁, 张宇. 空间相机焦平面CCD交错拼接重叠像元数计算[J]. 光学精密工程, 2016,24(2): 422-429

WU Yi-nan, LI Guo-ning, ZHANG Yu. Calculation of overlapping pixels in interleaving assembly for CCD focal plane of space camera[J]. Editorial Office of Optics and Precision Engineering, 2016,24(2): 422-429
武奕楠, 李国宁, 张宇. 空间相机焦平面CCD交错拼接重叠像元数计算[J]. 光学精密工程, 2016,24(2): 422-429 DOI： 10.3788/OPE.20162402.0422.

WU Yi-nan, LI Guo-ning, ZHANG Yu. Calculation of overlapping pixels in interleaving assembly for CCD focal plane of space camera[J]. Editorial Office of Optics and Precision Engineering, 2016,24(2): 422-429 DOI： 10.3788/OPE.20162402.0422.

摘要

针对大视场空间相机焦平面采用的多片CCD交错拼接

提出了一种适用于多种姿态模式的重叠像元数解析计算方法

以保证空间相机成像视场中不出现漏缝。分析了CCD交错拼接的成像特性和产生漏缝的原因;基于空间坐标系变换和中心投影共线方程建立了重叠像元数计算模型

对像点、相机摄像中心、地面景物点建立动态数学关系

通过追踪像点在像面上的运动轨迹计算了拼接缝像元重叠情况。结合实际工程样例

计算和分析了空间相机机动角度、星下点纬度、视场位置等因素对重叠像元数的影响

并将各工况下计算的最多漏像元数作为最终拼接量。结果表明:重叠像元数理论误差小于1 pixel;对比侧摆

俯仰成像时所需拼接像元数更多;该计算模型可扩展应用于其他类型空间相机在任何姿态模式下的重叠像元数计算。

Abstract

The focal plane of a wide-field space camera is comprised of several staggered Charge Coupled Device(CCD) detectors.To eliminate the gap in imaging field of the space camera

this paper proposes an analytic calculation method for overlapping pixels applied to multiple maneuvering angle modes. The imaging characteristics of CCD interleaving assembly and the reason that imaging gaps appear were analyzed. Then

the calculation model for overlapping pixels was established by combining space coordinate transformation with a collinearity equation. The dynamic mathematical relationship of the image point

camera center and the ground point was established. The overlapping pixels between adjacent CCDs were calculated by tracing the locus of image point on the image plane. With an engineering example

the influence of maneuvering angle

subastral latitude and the field location of the space camera on overlapping pixels was calculated and analyzed and the maxmum number of gap pixels calculating among different working situations were considered as mechanical assembly numbers. The result shows that the theoretical error of the number overlapping pixels is less than 1 pixel. Comparing with scrolling imaging

the pitching imaging needs more number of assembly pixels. The computing model can be applied to other space cameras of different types

and the overlapping pixels can be calculated at any attitude mode.

关键词

Keywords

references

张星祥,任建岳. TDICCD焦平面的机械交错拼接[J]. 光学学报,2006,26(5):740-745. ZHANG X X, REN J Y.Mechanical interleaving assembly of TDICCD focal plane[J].Acta Optical Sinica, 2006, 26(5):740-745.(in Chinese)

ROGALSKI A. Progress in focal plane array technologies[J]. Progress in Quantum Electronics, 2012, 36(2-3):342-473.

李伟雄, 闫得杰, 王栋,等. 高分辨率空间相机俯仰成像的像移补偿方法[J]. 红外与激光工程,2013,42(9):2443-2448. LI W X, YAN D J, WANG D, et al..Image motion compensation method of high resolution space camera's imaging with pitch angle[J]. Infrared and Laser Engineering, 2013,42(9):2443-2448.(in Chinese)

武星星,刘金国. 基于地球椭球的空间相机侧摆摄影像移补偿[J]. 光学精密工程, 2014, 22(2):352-359. WU X X, LIU J G. Image motion compensation of scroll imaging for space camera based on earth ellipsoid[J].Opt. Precision Eng.,2014, 22(2):352-359.(in Chinese)

吕恒毅,刘扬,郭永飞. 遥感相机焦面CCD机械拼接中重叠像元数的确定[J]. 光学精密工程,2012,20(5):1041-1047. LV H Y, LIU Y,GUO Y F, Computation of overlapping pixels of mechanical assembly CCD focal planes in remote sensing cameras[J].Opt. Precision Eng., 2012, 20(5):1041-1047.(in Chinese)

郭疆,龚大鹏,朱磊,等. 测绘相机焦平面CCD交错拼接中重叠像元数计算[J]. 光学精密工程,2013,21(5):1251-1257. GUO J, GONG D P, ZHU L, et al..Calculation of overlapping pixels in interleaving assembly of CCD focal plane of mapping camera[J].Opt. Precision Eng., 2013, 21(5):1251-1257.(in Chinese)

王运,孙胜利,林长青. 空间相机交错拼接线阵探测器重叠像元数计算[J]. 光学学报,2014,34(1):1-7. WANG Y, SUN SH L, LIN CH Q.Calculation of over lapping pixels of staggered linear array detectors for space camera[J]. Acta Optica Sinica, 2014, 34(1):1-7.(in Chinese)

闫得杰,徐抒岩,韩诚山. 飞行器姿态对空间相机像移补偿的影响[J]. 光学精密工程,2008,16(11):2199-2203. YAN D J, XU SH Y, HAN CH SH.Effect of aerocraft attitude on image motion compensation of space camera[J]. Opt. Precision Eng., 2008, 16(11):2199-2203.(in Chinese)

王家琪, 于平, 颜昌翔,等. 航天光学遥感器像移速度矢计算数学模型[J]. 光学学报, 2004, 24(12):1585-1589. WANG J Q, YU P, YAN CH X, et al..Space optical remote sensor image motion velocity vector computational modeling[J]. Acta Optica Sinica,2004, 24(12):1585-1589.(in Chinese)

李广泽,孔德柱,刘金国. 宽覆盖型光学遥感相机侧摆像移速度计算[J]. 中国光学, 2013, 6(5):751-757. LI G Z, KONG D ZH, LIU J G. Computation of scroll image motion velocity of wide coverage optical remote camera[J].Chinese Optics, 2013,6(5):751-757.(in Chinese)

杨秀彬, 贺小军, 张刘,等. 偏流角误差对TDICCD相机成像的影响与仿真[J]. 光电工程,2008,35(11):45-50. YANG X B, HE X J, ZHANG L, et al.. Effect and simulation of the deviant angle error on TDICCD cameras image[J]. Opto-Electronic Engineering, 2008, 35(11):45-50.(in Chinese)

胡燕, 金光, 常琳, 等. 椭圆轨道TDICCD相机像移匹配计算与成像验证[J]. 光学精密工程,2014, 22(8):2274-2284. HU Y, JIN G, CHANG L, et al.. Image motion matching calculation and imaging validation of TDI CCD camera on elliptical orbit[J]. Opt. Precision Eng., 2014, 22(8):2274-2284.(in Chinese)

Views

459

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Carbon fiber thin-walled cylindrical support structure between primary and secondary mirror in space camera

Design and analysis of the repeatable development and collapse mechanism film protective cover of space camera

Design of imaging model for cone-pendulum scanning integrated space camera

Application of metal rubber vibration absorber in coaxial dual-reflection space camera

Research on dynamic characteristics of space camera focusing platform

Related Author

Xunpeng SONG

Xiaoxue GONG

Lei ZHANG

Jian YUAN

Yunfei YANG

Hong XIAO

Hong-yang WANG

Hong-wei GUO

Related Institution

Chang Guang Satellite Technology Co.Ltd

State Key Laboratory of Robotics and System， Harbin Institute of Technology

Tiandi Technology Co.， Ltd.

Institute of Optics and Electronics， Chinese Academy of Sciences

Changchun Institute of Optics，Fine Mechanics and Physics，Chinese Academy of Sciences

AI问答

Address：No.3888 Dong Nanhu Road, Changchun, Jilin, China Postal code：130033
Tel：0431-86176855 Email：gxjmgc@ciomp.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 吉ICP备11002662号-17 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰