Error modification of FBG strain sensors bonded on plates

WU Ru-jun; FU Kun-kun; ZHENG Bai-lin; SUN Dian-liang

doi:10.3788/OPE.20162404.0747

您当前的位置：

首页 >

文章列表页 >

Error modification of FBG strain sensors bonded on plates

更新时间：2020-08-13

- Error modification of FBG strain sensors bonded on plates
- Optics and Precision Engineering Vol. 24, Issue 4, Pages: 747-755(2016)
- 作者机构：
  
  1. 同济大学航空航天与力学学院上海,200092
  2. 上海电机学院机械学院上海,201306
  3. 哈尔滨船舶锅炉涡轮机研究所,黑龙江哈尔滨,150078
  4. 山东省邮电工程有限公司,山东济南,250001
- 作者简介：
- 基金信息：
- DOI：10.3788/OPE.20162404.0747
  CLC： TN253
- Received：09 December 2015，
  
  Revised：05 January 2016，
  
  Published：25 April 2016
- 稿件说明：
移动端阅览
吴入军, 付昆昆, 郑百林等. 粘贴于薄板表面的光纤布拉格光栅应变传感器误差修正[J]. 光学精密工程, 2016,24(4): 747-755

WU Ru-jun, FU Kun-kun, ZHENG Bai-lin etc. Error modification of FBG strain sensors bonded on plates[J]. Editorial Office of Optics and Precision Engineering, 2016,24(4): 747-755
吴入军, 付昆昆, 郑百林等. 粘贴于薄板表面的光纤布拉格光栅应变传感器误差修正[J]. 光学精密工程, 2016,24(4): 747-755 DOI： 10.3788/OPE.20162404.0747.

WU Ru-jun, FU Kun-kun, ZHENG Bai-lin etc. Error modification of FBG strain sensors bonded on plates[J]. Editorial Office of Optics and Precision Engineering, 2016,24(4): 747-755 DOI： 10.3788/OPE.20162404.0747.

摘要

考虑现有光纤布拉格光栅(FBG)传感器的应变传递理论均未考虑传感器对基体应变的影响

本文针对FBG传感器粘贴于薄板的情况研究了薄板的应变传递理论。由于光纤应变与薄板应变并不相等

故研究了光纤应变与薄板应变之间的关系以提高FBG传感器的测量精度。建立了粘贴于薄板表面的FBG传感器应变传递理论

分析了FBG传感器与薄板之间的相互作用;利用有限元法(FEM)和实验法验证了理论的正确性。最后

分析了薄板参数对应变传递率的影响。结果显示:FEM解与理论解的误差在4%以内

实验值和理论解误差在5%以内

应变传递率随着薄板厚度和弹性模量的增加而逐渐增大。该理论模型完全满足FBG传感器精度要求

对其实际应用具有一定的指导意义。

Abstract

As the strain transfer theory of existing Fiber Bragg Grating(FBG) sensors does not take its effect on basic material strain into account

this paper researches the strain transfer theory for a FBG sensor bonded on a plate. The strain of an optical fiber is different from that of the plate

so the strain relationship between the optical fiber and the plate was studied to improve the measurement accuracy of FBG sensors. A theoretical model of strain transfer of FBG sensors bonded on the plate was presented

and the interaction between the FBG sensor and the plate was analyzed. Then the theoretical predictions were validated by Finite Element Method(FEM) and experimental data. Finally

the effect of the parameters of the plate on the strain transfer rate was analyzed. The results show that the error between the FEM and theoretical solution has controlled within 4% and that between the FEA and experimental data has controlled within 5%. Moreover

the strain transfer rate increases with the increases of both thickness and Young's modulus of the plate. It concludes that the theoretical model satisfies the accuracy requirement of the FBG sensors

and could provide a design reference for the FBG sensors.

关键词

Keywords

references

徐国权, 熊代余. 光纤光栅传感器技术在工程中的应用[J]. 中国光学, 2013, 6(3):306-317. XU G Q, XIONG D Y. Applications of fiber Bragg grating sensing technology in engineering[J]. Chinese Optics, 2013, 6(3):306-317.(in Chinese)

ANSARI F, LIBO Y. Mechanics of bond and interface shear transfer in optical fiber sensors[J]. Journal of Engineering Mechanics, 1998, 124(4):385-394.

LI D S, LI H N. Strain transferring of embedded fiber Bragg grating sensors[J]. Smart Materials and Structures, 2005, 5765(1):1085-1093.

LI D S, LI H N, REN L, et al.. Strain transferring analysis of fiber Bragg grating sensors[J]. Optical Engineering, 2006, 45(2):024402.

ZHOU Z, LI J L, OU J P. Interface strain transfer mechanism and error modification of embedded FBG strain sensors[J]. Smart Materials and Structures, 2004, 5384:190-198.

LI J L, ZHOU Z, OU J P. Interface transferring mechanism and error modification of embedded FBG strain sensor based on creep part[J]. Smart Materials and Structures, 2005, 5765(1):1061-1072.

常新龙, 黎明, 王渭平, 等. 埋入式聚合物光纤传感器应变传递影响参数分析[J]. 激光与红外, 2010, 40(5):515-519. CHANG X L, LI M, WANG W P, et al.. Analyses of parameters influencing strain transfer of embedded polymer optical fiber sensors[J]. Laser & Infrared, 2010, 40(5):515-519. (in Chinese)

HER S C, HUANG C Y. Effect of coating on the strain transfer of optical fiber sensors[J]. Sensors, 2011, 11(7):6926-6941.

梁德志, 孙丽, 黄昌铁, 等. 埋入式FBG传感器应变传递的有限元计算与理论分析比较[J]. 沈阳建筑大学学报, 2008, 24(1):72-76. LIANG D ZH, SUN L, HUANG CH T, et al.. Comparison of strain transfer of embedded FBG sensors calculated by FEM and theory formula[J]. Journal of Shenyang Jianzhu University, 2008, 24(1):72-76.(in Chinese)

WANG Q B, QIU Y, ZHAO H T, et al.. Analysis of strain transfer of six-layer surface-bonded fiber Bragg gratings[J]. Applied Optics, 2012, 51(18):4129-4138.

ZHAO H T, WANG Q B, QIU Y, et al.. Strain transfer of surface bonded fiber Bragg grating sensors for airship envelope structural health monitoring[J]. Journal of Zhejiang University-Science A(Applied Physics & Engineering), 2012, 13(7):538-545.

吴入军, 郑百林, 贺鹏飞, 等. 埋入式光纤布拉格光栅传感器封装结构对测量应变的影响[J]. 光学精密工程, 2014, 22(1):22-30. WU R J, ZHENG B L, HE P F, et al.. Influence of encapsulation structures for embedded fiber-optic Bragg grating sensors on strain measurement[J]. Opt. Precision Eng., 2014, 22(1):22-30. (in Chinese)

MCRADI M, SIVOTHTHAMAN S. Strain transfer analysis of surface-bonded MEMS strain sensors[J]. IEEE Sensors Journal, 2013, 13(2):637-643.

吴家龙.弹性力学[M]. 上海:同济大学出版社, 1993. WU J L. Theory of Elasticity[M]. Shanghai:Tongji University Press, 1993. (in Chinese)

周智, 李冀龙, 欧进萍. 埋入式光纤光栅界面应变传递机理与误差修正[J]. 哈尔滨工业大学学报, 2006, 38(1):49-55. ZHOU ZH, LI J L, OU J P. Interface strain transfer mechanism and error modification of embedded FBG strain sensors[J]. Journal of Harbin Institute of Technology, 2006, 38(1):49-55. (in Chinese)

Views

337

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on factors influencing the pointing accuracy of large telescopes and the correction model

Calibration and correction of geometric errors in laser tracker

Correction of probe alignment error for ZC1 worm gear profile measurement

Model establishment and error correction of FMCW lidar

Correction method for angle measurement error of eccentric encoder with double read-heads installed non-diametrically opposite

Related Author

CHEN Baogang

XIA Haojie

ZHANG Jin

WANG Jianli

CAO Yuyan

WANG Shan

ZHANG Zili

DONG Dengfeng

Related Institution

Changchun Institute of Optics，Fine Mechanics and Physics，Chinese Academy of Sciences

Hefei University of technology，College of Instrument Science and Optoelectronic Engineering

University of Chinese Academy of Sciences

Institute of Microelectronics of the Chinese Academy of Sciences

Beijing Engineering Research Center of Precision Measurement Technology and Instruments， Faculty of Materials and Manufacturing， Beijing University of Technology

AI问答

Address：No.3888 Dong Nanhu Road, Changchun, Jilin, China Postal code：130033
Tel：0431-86176855 Email：gxjmgc@ciomp.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 吉ICP备11002662号-17 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰