Bai-jun LONG, Long OU, Ru-jian XIANG, et al. Optimization of control strategy for FSM system by using simulated annealing algorithm[J]. Optics and precision engineering, 2016, 24(9): 2232-2239.
DOI:
Bai-jun LONG, Long OU, Ru-jian XIANG, et al. Optimization of control strategy for FSM system by using simulated annealing algorithm[J]. Optics and precision engineering, 2016, 24(9): 2232-2239. DOI: 10.3788/OPE.20162409.2232.
Optimization of control strategy for FSM system by using simulated annealing algorithm
Fast Steer Mirrors(FSMs) should possess different effective bandwidths and close bandwidths under different situations. So this paper establishes a system model based on a piezoelectric FSM control system
and optimizes the control strategy for the FSM system by analyzing the jitter of an optical axis. Firstly
close loop Bode figure of the system was measured
the simulated annealing algorithm was used to achieve the modulation transfer function of the system model. By combining simulated annealing algorithm and the identified model
an optimal PID controller to meet all kinds of applications was presented. Finally
the step response tests were used to verify the correctness of the identification model
and the closed-loop tests were taken to validate the effectiveness of the optimal controller. Experimental results indicate that the indentified model fits the FSM system very well in low-middle frequency stage
its step response is similar. The system controlled by the optimal controller has a closed-loop bandwidth of 70 Hz
an effective bandwidth of 35 Hz
and the tracking accuracy is improved by 47%
meeting the requirements of FSMs in the current environment. It concludes that the system has good low frequency tracking ability and high frequency interference rejection ability
showing high tracking precision and low device loss.
PENG SH P, YU H J, WANG W G, et al.. Design of servo for novel fast-steering mirror[J].Infrared and Laser Engineering, 2014, 43(5):1610-1615.(in Chinese)
WEN J H, ZHAO CH SH, JIANG F E, et al.. Study of driving and controlling with fast steering mirror based on PZT[J]. Ordnance Industry Automation, 2015, 34(8):59-64.(in Chinese)
XU X X, GAO Y G, YANG H B, et al.. Large-diameter fast steering mirror on rigid support technology for dynamic platform[J].Opt. Precision Eng., 2014, 22(1):117-124.(in Chinese)
YAN H, YE Y D, GAO Q S, et al.. Coherent beam combination of two 120 W solid state lasers with high beam quality[J]. High Power Laser and Particle Beams, 2014, 26(8):111-115.(in Chinese)
WANG Q, CHEN K, FU CH Y. Method for controlling fast-steering mirror drive by voice coil motor based on the closed-loop performance[J]. Opto-Electronic Engineering, 2005, 32(2):9-11.(in Chinese)
TIAN F Q, LI K Y, WANG J, et al.. Adaptive backstepping sliding mode control of fast steering mirror driven by piezoelectric actuator[J]. High Power Laser and Particle Beams, 2014, 26(1):59-63.(in Chinese)
YANG D, MAO Y, DING K, et al.. Application of model reference adaptive algorithm in fast-steering mirrors[J]. Infrared and Laser Engineering, 2013, 42(10):2790-2795.(in Chinese)
LIU Y K, ZHANG Y L, GENG T W, et al.. Design and study of measurement system for resonant characteristics of fast steering mirror[J]. Instrument Technique and Sensor, 2015(11):62-64.(in Chinese)
WANG SH, CHEN T, LI H W, et al.. Frequency characteristic test and model identification for O-E tracking servo system[J]. Opt. Precision Eng., 2009, 17(1):78-84.(in Chinese)
HU H J, MA J G, WANG Q, et al.. Transfer function identification in a fast steering mirror system[J]. Opto-Electronic Engineering, 2005, 32(7):1-3.(in Chinese)
王云.电力系统动态参数辨识及暂态稳定紧急控制算法研究[D].杭州:浙江大学, 2014.
WANG Y. Research on Dynamic Parameter Identification and Transient Stability Constrained Emergency Control[D]. Hangzhou:Zhejiang University, 2014.(in Chinese)
TANG H B, ZHU Y CH. Parameter identification of hysteresis model for giant magnetostrictive actuator based on jiles-atherton model[J]. Piezoelectrics & Acoustooptics, 2015, 37(5):863-866.(in Chinese)
李香平, 张红阳.模拟退火算法原理及改进[J].软件导刊, 2008, 4:47-48.
LI X P, ZHANG H Y. Improvement of Simulated Annealing Algorithm[J]. Software Guide, 2008, 4:47-48.(in Chinese)
何芝强. PID控制器参数整定方法及其应用研究[D].杭州:浙江大学, 2005.
HE ZH Q. Research on PID Controller Parameter Modify and Application[D]. Hangzhou:Zhejiang University, 2005.(in Chinese)