Ultrasonic detection of rich-resin in low-porosity CFRP

Xiang ZENG; Chen-long YANG; Xiao-jun ZHOU; Guo-yang TENG

doi:10.3788/OPE.20182611.2732

您当前的位置：

首页 >

文章列表页 >

Ultrasonic detection of rich-resin in low-porosity CFRP

Micro/Nano Technology and Fine Mechanics | 更新时间：2020-07-05

- Ultrasonic detection of rich-resin in low-porosity CFRP
- Optics and Precision Engineering Vol. 26, Issue 11, Pages: 2732-2743(2018)
- 作者机构：
  
  1.浙江大学流体动力与机电系统国家重点实验室, 浙江杭州 310027
  2.中车株洲电力机车研究所有限公司, 湖南株洲 412001
- 作者简介：
- 基金信息：
- DOI：10.3788/OPE.20182611.2732
  CLC： TB553
- Received：30 March 2018，
  
  Accepted：25 April 2018，
  
  Published：25 November 2018
- 稿件说明：
移动端阅览
Xiang ZENG, Chen-long YANG, Xiao-jun ZHOU, et al. Ultrasonic detection of rich-resin in low-porosity CFRP[J]. Optics and precision engineering, 2018, 26(11): 2732-2743.
DOI：

Xiang ZENG, Chen-long YANG, Xiao-jun ZHOU, et al. Ultrasonic detection of rich-resin in low-porosity CFRP[J]. Optics and precision engineering, 2018, 26(11): 2732-2743. DOI： 10.3788/OPE.20182611.2732.

摘要

针对孔隙率接近0的小孔隙率碳纤维复合材料（Carbon Fiber Reinforced Composite，CFRP）的富树脂检测需求，提出富树脂超声检测技术。对超声检测信号中的噪声消除方法、衰减抑制方法和富树脂检测的多视图成像技术进行研究，并开发小孔隙率CFRP富树脂超声检测软件。首先提出共振频率估计方法，通过低通滤波抑制高频随机噪声。其次根据频率差异，应用变分模态分解算法分离并消除共振结构噪声，提取低频成分。该低频成分包括表面回波、底面回波、富树脂反射信号和由层间反射信号、材料散射噪声等构成的相干噪声。再次，引入瞬时幅值比修正低频成分的幅值衰减并描述被检测小孔隙率CFRP的局部反射能力。最后，应用Otsu多阈值方法自适应获得富树脂识别的阈值，消除相干噪声的影响，完成富树脂识别。进一步对小孔隙率CFRP的超声检测结果进行多视图成像，在三维视图、C扫描视图和B扫描视图内识别富树脂。结果表明：变分模态分解的分量数为2，Otsu多阈值的类别数为3时，能够准确识别小孔隙率CFRP超声检测信号中的富树脂反射信号；采用0.15作为多视图成像的阈值，可简洁有效地描述富树脂在小孔隙率CFRP中的分布。

Abstract

To satisfy the demand of rich-resin defect detection in the so-called low-porosity carbon fiber reinforced composite (CFRP) with porosity close to zero

an ultrasonic testing methodology was proposed in this article. The denoising methods

attenuation suppression method

and 3D imaging technology for rich-resin identification are investigated

and low-porosity CFRP rich-resin detection software was developed. The rich resin was detected in four steps. First

the resonant frequency was estimated

and the high-frequency stochastic noise was suppressed. Second

variational mode decomposition (VMD) was used to separate the resonant structure noise and extract the low-frequency component. The low-frequency component consisted of the front-wall echo

back-wall echo

rich-resin reflection signal

and remaining coherent noise made up of the interlayer reflection signals and material scattering noise. Third

the instant amplitude ratio was introduced to correct the envelop attenuation of the low-frequency component and describe the local reflectivity of the low-porosity CFRP. Finally

the multi-threshold Otsu method was used to search the threshold of the rich-resin detection

resulting in the elimination of interference and finishing the detection of rich resin. Further

multi-view imaging was performed on the test results

and the rich resin was identified in the 3D

C-scan

and B-scan imaging processes. The experimental results show that when the VMD mode was set to two and the classes in the multi-threshold Otsu method are set to three

a rich-resin reflection signal can be detected. When the threshold in the multi-view imaging is set to 0.15

the rich resin can be effectively characterized.

关键词

Keywords

references

周正干, 肖鹏, 刘航航.航空复合材料先进超声无损检测技术[J].航空制造技术, 2013, 424(4):38-43.

ZHOU ZH G, XIAO P, LIU H H. Advanced ultrasonic testing technology for aviation composites[J]. Aeronautical Manufacturing Technology , 2013, 424(4):38-43.(in Chinese)

路士增, 林兰波, 姜明顺, 等.基于光纤光栅传感器的复合材料损伤识别系统[J].光学精密工程, 2014, 22(11):2894-2901.

LU SH Z, LIN L B, JIANG M SH, et al .. Identification system of composite material damage based on FBG sensor[J]. Opt. Precision Eng ., 2014, 22(11):2894-2901.(in Chinese)

周晓军, 游红武, 程耀东.含孔隙碳纤维复合材料的超声衰减模型[J].复合材料学报, 1997, 14(3):100-107.

ZHOU X J, YOU H W, CHENG Y D. Ultrasonic attenuation model of void contained carbon-fibre reinforced plastic[J]. Acta Materiae Compositae Sinica , 1997, 14(3):100-107.(in Chinese)

LIN L, CHEN J, ZHANG X, et al .. A novel 2-D random void model and its application in ultrasonically determined void content for composite materials[J]. NDT & E International , 2011, 44(3):254-260.

胡宏伟, 李雄兵, 杨岳, 等. CFRP复杂型面构件的孔隙率超声检测方法[J].中南大学学报(自然科学版), 2012, 43(4):1315-1319.

HU H W, LI X B, YANG Y, et al .. Method of inspecting porosity in CFRP with complex surface by ultrasonic[J]. Journal of Central South University(Science and Technology) , 2012, 43(4):1315-1319.(in Chinese)

林莉, 罗明, 郭广平, 等.碳纤维复合材料孔隙率超声声阻抗法检测[J].复合材料学报, 2009, 26(3):105-110.

LIN L, LUO M, GUO G P, et al ..Ultrasonic determination of carbon fiber composite porosity using acoustic impedance[J]. Acta Materiae Compositae Sinica , 2009, 26(3):105-110.(in Chinese)

KIM K B, HSU D K, BARNARD D J. Estimation of porosity content of composite materials by applying discrete wavelet transform to ultrasonic backscattered signal[J]. NDT & E International , 2013, 56:10-16.

LOZAK A, BOLLER C, BULAVINOV A, et al .. Phase statistics and spectral analysis of ultrasonic signals for CFRP component assessment[C]. European Workshop on Structural Health Monitoring , 2014: 2290-2297.

何晓晨, 金士杰, 林莉.超声背散射信号递归定量分析无损表征CFRP孔隙分布仿真[J].复合材料学报, 2018:1-6.

HE X CH, JIN SH J, LIN L. Simulation on non-destructive evaluation of CFRP void distribution with recurrence quantification analysis of ultrasonic back-scatter signals[J]. Acta Materiae Compositae Sinica , 2018:1-6.(in Chinese)

MIENCZAKOWSKI M. Advanced ultrasonic NDE of composite airframe components: physics, modelling and technology [D]. Nottingham: University of Nottingham, 2010.

陈越超, 杨辰龙, 周晓军, 等.厚截面CFRP孔隙超声脉冲反射检测方法[J].振动、测试与诊断, 2016, 36(3):425-431.

CHEN Y CH, YANG CH L, ZHOU X J, et al .. Study of ultrasonic pulse echo method for voids test in thick-section CFRP[J]. Journal of Vibration, Measurement & Diagnosis , 2016, 36(3):425-431.(in Chinese)

HUANG N E, SHEN Z, LONG S R, et al .. The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysis[C]. Proceedings Mathematical Physical & Engineering Sciences , 1998: 903-995.

DRAGOMIRETSKIY K, ZOSSO D. Variational mode decomposition[J]. IEEE Transactions on Signal Processing , 2014, 62(3):531-544.

申铉京, 刘翔, 陈海鹏.基于多阈值Otsu准则的阈值分割快速计算[J].电子与信息学报, 2017, 39(1):144-149.

SHEN X J, LIU X, CHEN H P. Fast computation of threshold based on multi-threshold Otsu criterion[J]. Journal of Electronics & Information Technology , 2017, 39(1):144-149.(in Chinese)

OTSU N. A threshold selection method from gray-level histograms[J]. IEEE Transactions on Systems Man & Cybernetics , 1979, 9(1):62-66.

Views

262

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Adjustable optical path cylindrical multi-pass cell TDLAS system

Adaptive denoising for laser detection signal of shell thickness based on variational mode decomposition

Variational mode decomposition for phase retrieval in fringe projection 3D shape measurement

Adjustable optical path cylindrical multi-pass cell TDLAS system

Related Author

FANG Hongfu

YUAN Haotian

YANG Le

LIU Huiyuan

LI Hui

SHI Yongpeng

NIU Mingsheng

LI Taohua

Related Institution

School of Physical and Physical Engineering， Qufu Normal University， Qufu

Scholl of Electrical Engineering and Automation, Harbin Institude of Technology

School of Electrical Engineering and Automation, Tianjin Polytechnic University

School of Electronic Information Engineering, Tianjin University

AI问答

Address：No.3888 Dong Nanhu Road, Changchun, Jilin, China Postal code：130033
Tel：0431-86176855 Email：gxjmgc@ciomp.ac.cn
Technical support is provided by Beijing Founder electronics co., LTD 吉ICP备11002662号-17 京公网安备11010802024621
It is recommended to read the content of this site in Chrome&IE9+. Please switch to extreme mode in browser 360.
Cookies We use cookies to help provide and enhance our service and tailor content. By continuing, you agree to the use of cookies.

⁰