Φ25mm火炮身管直线度光电测量方法

张连存; 张国玉; 付秀华; 杨立保; 孙天祥; 李清安; 方杨

doi:null

您当前的位置：

首页 >

文章列表页 >

Φ25mm火炮身管直线度光电测量方法

现代光学仪器与精密机械 | 更新时间：2020-08-12

- Φ25mm火炮身管直线度光电测量方法
- Optoelectronic method for measuring the straightness of the bore with a diameter of 25 mm
- 光学精密工程 2004年12卷第5期页码：485-490
- 作者机构：
  
  1. 长春理工大学,吉林长春,130022
  2. 中国科学院, 长春光学精密机械与物理研究所, 吉林, 长春, 130033
- 作者简介：
- 基金信息：
  
  中国兵器工业集团技术改造项目(No.F102-030047)()
- DOI：
  中图分类号： TJ06
- 收稿日期：2004-07-10，
  
  修回日期：2004-08-18，
  
  网络出版日期：2004-10-15，
  
  纸质出版日期：2004-10-15
- 稿件说明：
移动端阅览
张连存, 张国玉, 付秀华, 杨立保, 孙天祥, 李清安, 方杨. Φ25mm火炮身管直线度光电测量方法[J]. 光学精密工程, 2004,(5): 485-490

ZHANG Lian-cun, ZHANG Guo-yu, FU Xiu-hua, YANG Li-bao, SUN Tian-xiang, LI Qing-an, FANG Yang. Optoelectronic method for measuring the straightness of the bore with a diameter of 25 mm[J]. Editorial Office of Optics and Precision Engineering, 2004,(5): 485-490
张连存, 张国玉, 付秀华, 杨立保, 孙天祥, 李清安, 方杨. Φ25mm火炮身管直线度光电测量方法[J]. 光学精密工程, 2004,(5): 485-490 DOI：

ZHANG Lian-cun, ZHANG Guo-yu, FU Xiu-hua, YANG Li-bao, SUN Tian-xiang, LI Qing-an, FANG Yang. Optoelectronic method for measuring the straightness of the bore with a diameter of 25 mm[J]. Editorial Office of Optics and Precision Engineering, 2004,(5): 485-490 DOI：

摘要

基于激光准直和光电探测原理与技术

并借鉴象限探测法、精密机械、伺服控制技术和计算机技术研制了一种用于Φ25mm火炮身管直线度的光电测量系统.给出了系统的总体结构

对系统的测量原理进行了理论分析

得到了身管直线度的计算公式

建立了解决光电靶偏心的数学模型.并将测量系统应用于长1.15m的Φ25mm精加工孔标准件进行两组采样

每组采样步长为100mm.实测的结果表明:测量系统分辨率可以达到0.005mm

测量误差小于0.015mm

重复性测量精度优于±0.009mm

说明测量方法是可行的.

Abstract

Based on the principle and technology of laser collimation and optoelectronic inspection

an optoelectronic measuring method is presented to measure the straightness of the bore with a diameter of 25 mm by using the quadrant detection method

technique of laser collimation

optoelectronic detection

precision machine

servocontrol and computer for reference. The overall structure of system is discussed

and the measuring principle of the system is analyzed. Then

the corresponding formula to calculate the straightness of the bore and the mathematics model to solve eccentricity of the optical drone are obtained. Then the system is used to measure a hole standard piece with the length of(1.15 m)and inner diameter of 25 mm

by sampling two groups of the data of straightness with the pedometer of 100 mm each. The results show that the system resolving power can reach 0.005 mm

the measuring error is not more than 0.015 mm

and the measuring repetition error superior to ?0.009 mm

Which indicates that the measuring method is applicable.

关键词

Keywords

references

中国兵器工业标准化研究所. WJ2096-92炮身测量[S] .中国兵器工业总公司部标准,1992.Institute of weapon industry standardization of China. WJ2096-92. the Measurement of bore [S] . Criterion of CNGC,1992.(in Chinese)

朱小平,池晓红. 激光多普勒技术与直线度测量[J] . 现代计量测试, 1995,(5):17-19.ZHU X P,CHI X H. Laser doppler technique and straightness measurements[J] . Modern Metrology and Test,1995,(5):17-19.(in Chinese)

WANG C P. Laser doppler displacement measurement[J] . Laser and Optronics,1987,6(9):69-71.

WANG C P. Using the laser doppler displacement meter for precision position and motion control[C] .Proceedings of the First Annual Motion Control Technology Conference West, 1990:143-149.

张国玉,安志勇,姜会林,等. 直线度误差的光电非接触测量方法[J] . 光学技术,1999,25(1):41-43.ZHANG G Y,AN ZH Y,JIANG H L, et al. Optoelectronic non-contact measuring method for straightness error[J] . Optical Technology, 1999,25(1):41-46.(in Chinese)

于瀛洁,张之江.激光束角漂移对双频激光直线度测量的影响[J] . 光电工程, 1998,25(4):55-61.YU Y J,ZHANG ZH J. The influence of beam angle shift on the measurement of straightness with double-frequency laser[J] .Opto-Electronic Engineer, 1998,25(4):55-61.(in Chinese)

赵辉,浦昭邦.基于双频激光干涉技术的高精度直线度基准装置[J] .中国激光,2001,28(7):587-590.ZHAO H,PU ZH B. High precision straightness device based on double-frequency laser interferences technique[J] . Chinese Journal Lasers,2001,28(7):587-590.(in Chinese)

刘国淦, 张学军.光纤点衍射干涉的技术研究[J] .光学精密工程,2001,9(2):142-145.LIU G J, ZHANG X J. Fiber point diffraction interferometer[J] . Optical and Precision Engineering, 2001,9(2):142-145.(in Chinese)

王权陡, 余景池. 像移干涉技术在小角度及直线度测量中的应用[J] .计量学报,2002,23(1):6-9.WANG Q D,YU J CH. Application of phase shift interferometry to the measurement of small angle and linearity[J] .Acta Metrological Sinica,2002,23(1):6-9.(in Chinese)

王宪平,李圣怡. 直线度误差组合分离方法及其误差分析[J] . 光学精密工程,1999,7(4):124-130.WANG X P, LI SH Y. Straightness measurement with a new combination method and its error analysis[J] .Optical and Precision Engineering, 1997,7(4):124-130.(in Chinese)

徐永凯. EST法测量深孔母线直线度的方案及其误差分析[J] .北京理工学报, 2000,20(4):431-434.XU Y K. Scheme and error analysis of generatrix straightness measurement for deep holes with EST[J] .Journal of Beijing Institute of Technology, 2000,20(4):431-434.(in Chinese)

CHANGKU S, RONGSHENG L. A Laser version test method for seamless steel pipe straightness[C] . In 1st International Symposium on Instrumentation Science and Technology.Luoyang,China,1999:594-597.

ZHANG L, ZHANG Y. Imitation analysis of the effect of initial-value error on straightness EST method in time-domain[C] . Proceedings of the ICPE'96 and 6 th SJSUT,1996:401-403.

陈海燕,海洁.直线度自动检查仪的研究[J] .工具技术,2002,36(5):34-35.CHEN H Y, HAI J. Development of straightness automatics tester[J] . Tool Engineering, 2002,36(5):34-35.(in Chinese)

史伟,廖俊必.基于图像处理的炮管轴线直线度检测方法[J] . 兵工自动化, 2002, 21(6):496-499.SHI W, LIAO J B. A measurement method of gun barrel axes straightness based on image processing[J] . Ordnance Industry Automation, 2002, 21(6):496-499.(in Chinese)

叶声华,杨学友. 大直径钢管直线度在线测量研究[J] .仪器仪表学报, 2001, 22(3):55-57.YE SH H,YANG X Y. Study on real-time linearity measurement of steel pipe with large diameter[J] .Chinese Journal of Scientific Instrument, 2001,22(3):55-57.(in Chinese)

李佳列,丁国清. 采用CCD的非接触测量中提高精度的一种方法[J] . 光学精密工程, 2002,10(3):241-243.LI J L,DING G Q. Method for improving precision in non-contact measurement by linear CCD[J] . Optical and Precision Engineering, 2002,10(3): 241 -243.(in Chinese)

马宏,潘毓学,车英. 炮管直线度激光检测设备研究[J] . 兵工学报, 2003, 24(2):261-263.MA H,PAN YU X,CHE Y. A study on a laser inspection device for the straightness of bore[J] .Acta Armamentarii, 2003, 24(2):261-263.(in Chinese)

吕海宝,湛廷政. CCD细分技术方法研究及应用[J] . 光学学报,2002,22(11):1396-1399.LU H B, ZHAN T ZH. CCD subdivision method and application[J] . Acta Optica Sinica, 2002,22(11):1396-1399.(in Chinese)

浏览量

493

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

激光准直测量中的空气随机扰动影响抑制

高精度激光光束准直系统设计

结合激光准直的二维转角动态测量系统

高精度无导轨位移平台误差分析

基于像差修正的同轴度测量方法