光学拼接镜面微位移主动调节机构的设计和实测

杨德华; 戚永军; 朱振东; 姜方华; 陈昆新; 张 如

doi:null

您当前的位置：

首页 >

文章列表页 >

光学拼接镜面微位移主动调节机构的设计和实测

更新时间：2020-08-12

- 光学拼接镜面微位移主动调节机构的设计和实测
- Design and test of the active micro-motion mechanism for optical mirror segement
- 光学精密工程 2005年13卷第2期页码：191-197
- 作者机构：
  
  中国科学院国家天文台南京天文光学技术研究所,江苏南京 210042
- 作者简介：
- 基金信息：
- DOI：
  中图分类号： TH751
- 收稿日期：2005-02-14，
  
  修回日期：2005-03-25，
  
  网络出版日期：2005-04-30，
  
  纸质出版日期：2005-04-30
- 稿件说明：
移动端阅览
杨德华, 戚永军, 朱振东, 等. 光学拼接镜面微位移主动调节机构的设计和实测[J]. 光学精密工程, 2005,13(2):191-197.

YANG De-hua, QI Yong-jun, ZHU Zhen-dong, et al. Design and test of the active micro-motion mechanism for optical mirror segement[J]. Optics and precision engineering, 2005, 13(2): 191-197.
杨德华, 戚永军, 朱振东, 等. 光学拼接镜面微位移主动调节机构的设计和实测[J]. 光学精密工程, 2005,13(2):191-197. DOI：

YANG De-hua, QI Yong-jun, ZHU Zhen-dong, et al. Design and test of the active micro-motion mechanism for optical mirror segement[J]. Optics and precision engineering, 2005, 13(2): 191-197. DOI：

摘要

设计和制造了一套微位移主动调节机构和支撑系统

用以实现拼接镜面天文光学望远镜的每块平面子镜精密地调节倾斜和轴向平移

并在典型的仰角工况下对该机构进行了实测。设计技术要求子镜主动调节行程须达±1 mm

同时分辨率须达50 nm以下。选用了工作行程为6 mm和分辨率为50 nm的位移促动器

并引入杠杆机构提高位移分辨率和抑制误差;采用平衡配重和预拉弹簧机构使工作中位移促动器上保持恒定负载

以保护位移促动器和保证其输出位移精度。依据拼接镜面的工作原理

建立了子镜微位移调节系统性能测试的数学模型

并在实验室内采用分辨率为5 nm的位移传感器进行了实测。结果表明其位移分辨率可达12 nm

线性良好

与理论值相对误差为5.6%

验证了该机构设计的合理性和在不同工作位置良好的灵敏度。

Abstract

Active micro-motion mechanism is fundamental for astronomical telescope using segmented mirror to form and maintain required figure by active tip-tilt and/or piston. Mechanical design and laboratory test of such an active mechanism for a mirror segment prototype are described. Technical requirement specifies that active motion range covers up to 2 mm with resolution down to 50 nm. Three displacement actuators with 6 mm working travel and 50 nm motion resolution are adopted with three sets of lever mechanism introduced to increase the resolution of displacement and to abate error in the system. Also

three sets of lever-weight-balance mechanism together with three pairs of tensional spring are integrated to ensure

despite of variable elevation angles of the telescope in operation

constant load on the displacement actuators

whereby the actuators are safely protected with stabler output displacement accuracy

which is undesirably load-dependent. Based on working philosophy of segmented mirrors

mathematical model and experimental method were established for the active micro-motion system to be tested in laboratory

for which displacement sensors of 5 nm output resolution are used. Measurement results have confirmed the feasible design of the active micro-motion mechanism with output displacement resolution as fine as 12 nm and transmission ratio error no greater than 5.6%

besides its execellent linearity and sensitivity.

关键词

Keywords

references

. 程景全. 天文望远镜原理和设计[M]. 北京:中国科学技术出版社, 2003. CHENG J Q. Principles of astronomical telescope design[M]. Beijing: Press of Science and Technology of China, 2003.

. BELY P Y. The design and construction of large optical telescopes[M]. Springer-Verlag, 2003.

. NELSON J E, MAST T S, FABER S M. Keck observatory report No. 90-the design of the Keck observatory and telescope(ten meter telescope) . 1985.

. KRABBENDAM V L. Development and performance of Hobby Eberly Telescope 11 meter segmented mirror[J]. SPIE, 2002, 3352:647-658.

. MYERS R M, LONGMORE A J, et al. The NAOMI adaptive optics system for the 4.2 m william herschel telescope[J]. SPIE,2002,4839:647-658.

. VUKOBRATOVICH D. Introduction to opto-mechanical design[M]. McGraw-Hill, 1993.

. 杨德华.MA子镜系统样机及相关支撑系统的设计 . 南京:中国科学院国家天文台南京天文光学技术研究所,2003. YANG D H. Design of MA unit prototype and its support system . Nanjing: National Astronomical Observatories/Nanjing Institute of Astronomical Optics and Technology, Chinese Academy of Sciences, 2003. (in Chinese)

. 孙立宁,荣伟彬,曲东升,等. 基于微操作的大行程高分辨率旋转微驱动器的研究[J]. 光学精密工程,2001,9(6):514-518. SUN L N,RONG W B,QU D S,et al.Research on a large travel and high resolution rotary micro-driver based on micro-manipulation[J].Optics and Precision Engineering,2001,9(6):514-518.(in Chinese)

. CUI X Q, LI Y P, NI X Y,et al. The active support system of LAMOST reflecting schmidt plate[J]. SPIE,2002,4837:628-636.

. Diamond Motion, Inc., Product Catalog-Diamond Motion Actuator Line Specifications[Z]. 2005.

. 杨德华.MA子镜系统样机检测 . 南京:中国科学院国家天文台南京天文光学技术研究所,2004. YANG D H. Test of MA segment prototype . Nanjing: National Astronomical Observatories/Nanjing Institute of Astronomical Optics and Technology, Chinese Academy of Sciences, 2004. (in Chinese)

. 石照耀,费业泰. 基于均值平移的动态测量重复性的评定方法研究[J]. 光学精密工程,2003,11(4):363-367. SHI Z Y,FEI Y T.Assessing the repeatablity of dynamic measurement based on mean line[J].Optics and Precision Engineering 2003,11(4):363-367.(in Chinese)

. Citterio O. Support system for the 1 m ESO active optics experiment . Proceedings of the IAU Colloquium, 1984: 41-56.

. 天津大学.纳米级CDJ-差动电容式位移传感器操作使用说明 .天津大学,2004. Tianjin university. Nanometer differential capacitive displacement sensor-model CDJ - user guide[M]. Tianjin University,2004.(in Chinese)

浏览量

330

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

基于光敏阵列直接调制的单栅式时栅位移传感器

基于卡尔曼滤波的激光外差干涉位移测量误差补偿

超精密空间分离式外差利特罗平面光栅编码器位移测量系统

面向浸没式光刻机的超精密光学干涉式光栅编码器位移测量技术研究综述

用于高精度测量位移等参量的光纤多波长激光器