
浏览全部资源
扫码关注微信
国家汽车零部件产品质量监督检验中心
收稿日期:2008-03-28,
修回日期:2008-06-19,
网络出版日期:2009-02-25,
纸质出版日期:2009-02-25
移动端阅览
凌铭. 基于二维平面移动的车灯配光检测系统[J]. 光学精密工程, 2009,17(2): 262-266
Ling Ming. Light Distribution Test System Based on Moving in Two-dimentional Plane[J]. Editorial Office of Optics and Precision Engineering, 2009,17(2): 262-266
为提高机动车车灯配光性能检测精度,降低成本,研制了一种新型的平面移动式车灯配光检测系统,与目前国内通用的转台式车灯配光测试系统精度比较后,分析了两种系统的信号灯最佳测试距离。通过前照灯的直接测量和角度换算,计算出国标规定测试点的坐标值误差;用校准照度计,计算出测试点的光照度值误差。结果表明,该测试系统的定位精度为0.1mm,比转台式系统提高42倍,照度精度0.02lx
提高了2倍;该测试系统信号灯发光强度测试精度与测试距离成正比,而转台式测试系统的有一个最佳测试距离,不是国内通用的3.16米。该检测系统精度高,车灯测试距离可调,易于控制,满足国标测试要求。
In order to raise the accuracy of light distribution test of automotive lamp and cut the cost about test system
a new-style system for light distribution test of automotive lamp was reserched
which could test luminance of every poit on light screen
and used two servo motors to control shaft with screw thread
based on moving in two-dimentional plane. After comparing to accuracy of the curent rotating desk system with the best precision in China
the best test distance of automotive signal light luminous intensity to two kinds of test systems was analyzed.Through director test and angle transformation of headlamp
the coordinate error of test points was caculated according to national standard
as well as luminance with standard lumeter. Experimental results indicate that the position precision of the system is 0.1 mm with an increase of 42 times over the curent rotating desk system
and luminance accuracy is 0.02lx tripled that of ones. Experiment to automotive signal light shows that the best test distance about the rotating desk system is found instead of 3.16m currently in China
and the luminance accuracy of new-style system is direct proportion to test distance. It can satisfy the system requirements of national standard with higher precision and rapid speed
the adjustable lamp tested distance as well as easy control.
0
浏览量
716
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621