窄通带高透过频率选择表面

苏学军; 高劲松; 朱华新; 赵晶丽; 冯晓国

doi:10.3788/OPE.20111903.0561

您当前的位置：

首页 >

文章列表页 >

窄通带高透过频率选择表面

现代应用光学 | 更新时间：2020-08-12

- 窄通带高透过频率选择表面
- Frequency selective surface with narrow passband and high transmittance
- 光学精密工程 2011年19卷第3期页码：561-566
- 作者机构：
  
  1. 中国科学院研究生院,北京 100039
  2. 海军航空工程学院,山东烟台 264001
  3. 中国科学院长春光学精密机械与物理研究所中国科学院光学系统先进制造技术重点实验室, 吉林长春 130033
- 作者简介：
- 基金信息：
  
  国家自然科学基金资助项目(No.60478053)()
- DOI：10.3788/OPE.20111903.0561
  中图分类号： TN975;TN761
- 收稿日期：2010-07-29，
  
  修回日期：2010-10-27，
  
  网络出版日期：2011-03-22，
  
  纸质出版日期：2011-03-22
- 稿件说明：
移动端阅览
苏学军, 高劲松, 朱华新, 赵晶丽, 冯晓国. 窄通带高透过频率选择表面[J]. 光学精密工程, 2011,19(3): 561-566

SU Xue-jun, GAO Jin-song, ZHU Hua-xin, ZHAO Jing-li, FENG Xiao-guo. Frequency selective surface with narrow passband and high transmittance[J]. Editorial Office of Optics and Precision Engineering, 2011,19(3): 561-566
苏学军, 高劲松, 朱华新, 赵晶丽, 冯晓国. 窄通带高透过频率选择表面[J]. 光学精密工程, 2011,19(3): 561-566 DOI： 10.3788/OPE.20111903.0561.

SU Xue-jun, GAO Jin-song, ZHU Hua-xin, ZHAO Jing-li, FENG Xiao-guo. Frequency selective surface with narrow passband and high transmittance[J]. Editorial Office of Optics and Precision Engineering, 2011,19(3): 561-566 DOI： 10.3788/OPE.20111903.0561.

摘要

为使大周期下带宽较窄的频率选择表面(FSS)结构透过率较高

以Y环单元为基础提出了一种提高通带透过率的新方法。该方法在周期单元内设置圆形孔径

通过增大占空比来提高透过率。运用谱域Galerkin方法数值分析了这种结构的传输特性

结果显示

确定

=0.5 mm

单元周期内圆孔个数为12时

中心频点10 GHz的透过率提高了0.11 dB。采用镀膜与光刻相结合的技术制备了相应的试验件

并进行了微波测试

测试值与计算值基本一致。开圆孔Y环的中心频点透过率在电磁波垂直入射的情况下为-0.62 dB

比对应Y环提高了0.21 dB

而在30和45倾斜入射的情况下

TE波的透过率分别为-0.66 dB和-0.81 dB

比对应Y环分别提高了0.32 dB和0.27 dB;-3 dB带宽分别为1 GHz和0.8 GHz

两种结构的带宽基本一致。得到的结果表明

提出的方法是大周期下提高通带透过率的一种行之有效的方法。

Abstract

On the basis of Y loop elements

a new method to set circular slots on the periodic element to improve the narrow bandwidth of a Frequency Selective Surface (FSS) structure was presented. The FSS structure was calculated by Galerkins method in the spectral domain when the optimum radius was set to be 0.5 mm and the number of the circular slots to be 12

and the transmittance in the resonance frequency of 10 GHz has increased by 0.11 dB. The plane sample was fabricated by depositing coatings and a lithograph technology

and obtained measured values are in good agreement with the calculated values. The results show that the transmittance of this structure is about -0.62 dB at the resonance frequency

which has increased by 0.21 dB under the perpendicularity incidence compared with that of the Y loop without circular slot. Furthermore

the transmittances at TE 30and 45incidence are -0.66 dB and -0.81 dB

respectively

which has increased about 0.32dB and 0.27dB compared with those from the Y loop without circular slots.The bandwidth difference between the two structures is negligible

which are about 1 GHz and 0.8 GHz under TE 30and 45incidence

respectively. These results indicate that this method is an effective way to improve the transmittance of large periodic FSS structure at the resonance frequency.

关键词

Keywords

references

WU T K. Frequency selective surface and grid array[M]. New York: A Wiley-interscience Publication, 1995.[2] MUNK B A. Frequency selective surface: Theory and Design[M]. New York: A Wiley-interscience Publication, 2000.[3] 卢俊,张靓,孙连春. Y形和Y环形单元特性的试验对比研究[J]. 光学精密工程,2005,13(2):219-224. LU J, ZHANG J, SUN L CH. Experimental comparison of the characteristics of Y element and Y loop element [J]. Opt. Precision Eng., 2005,13(2):219-224.(in Chinese)[4] MITTRA R, CHAN C H, CWIK T. Techniques for analyzing frequency selective surfaces-a review [J]. Proceeding of the IEEE, 1988,76(12):1593- 1615.[5] 侯新宇,万伟,佟明安,等. 带有多层介质衬底FSS的损耗和带宽特性分析[J]. 微波学报,1999,15(4):366-370. HOU X Y, WAN W, TONG M A, et al.. Analysis on the loss and bandwidth properties of FSS with multilayer dielectric substrates[J]. Journal of Microwave,1999,15(4):366-370.(in Chinese)[6] 李晓秋,高劲松,赵晶丽,等. 一种适用于雷达罩的频率选择表面新单元研究[J]. 物理学报,2008,57(6):3803-3806. LI X Q, GAO J S, ZHAO J L, et al.. A novel element of frequency selective surface for radome[J]. Acta Physica Sinaca, 2008,57(6):3803-3806.(in Chinese)[7] JIA H Y, GAO J S, FENG X G, et al.. Frequency selective surface with a flat topped passband[J]. Chin. Opt. Lett, 2007,5(12):715-716.[8] JIA H Y, GAO J S, FENG X G. Closely Packed Dense Frequency Selective Surface [J]. Chin. Opt. Lett, 2008,6(6):441-442.[9] URICH R. Far-infrared properties of metallic mesh and its complementary structure[J]. Infrared Physics,1967,7(1):37-57.[10] WHITBOURN L B, COMPTON R C. Equivalent-circuit formulas for metal grid reflectors at a dielectric boundary[J]. Appl.Opt,1985,24(2):217-220.[11] 冯晓国,方梁,孙连春. 金属网栅结构参数设计与制作[J]. 光学精密工程,2005, 13(1):59-64. FENG X G, FANG L, SUN L CH. Characteristic dimension design and fabrication of metallic mesh [J]. Opt. Precision Eng., 2005, 13(1):59-64.(in Chinese)[12] 刘小涵,冯晓国,赵晶丽,等. K9基底细薄铜网上的化学镀镍 [J]. 光学精密工程,2010,18(10):2185-2191. LIU X H,FENG X G,ZHAO J L,et al.. Electroless nickel plating of thin copper mesh on K9 substrate[J]. Opt. Precision Eng., 2010,18(10):2185-2191.(in Chinese)

浏览量

330

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

二信道光子晶体滤波系统

MEMS速率陀螺仪力平衡控制回路相位误差分析与验证

大口径红外光学系统透过率测量装置

单晶硅激光辅助超精密切削工艺优化与表面特性

基于动态粒子参数选择的水雾透过率计算