基于光纤布拉格光栅和压电转换器的电功率传感器

CHENG Chin-hsing; CHANG Min-chih; LIU Wen-fung

doi:10.3788/OPE.20111909.2255

您当前的位置：

首页 >

文章列表页 >

基于光纤布拉格光栅和压电转换器的电功率传感器

光学精密工程暨纳米科技国际研讨会论文 | 更新时间：2020-08-12

- 基于光纤布拉格光栅和压电转换器的电功率传感器
- Electrical power sensor based on fiber Bragg grating and piezo-electric transducer
- 光学精密工程 2011年19卷第9期页码：2255-2262
- 作者机构：
  
  Department of Electrical Engineering, Feng Chia University, Taichung,China,40724
- 作者简介：
- 基金信息：
  
  National Science Council of Republic of China(No.NSC 99-2221-E-035-100)()
- DOI：10.3788/OPE.20111909.2255
  中图分类号： TP212.13;TM933.3
- 收稿日期：2011-03-08，
  
  修回日期：2011-04-30，
  
  网络出版日期：2011-09-26，
  
  纸质出版日期：2011-09-26
- 稿件说明：
移动端阅览
CHENG Chin-hsing, CHANG Min-chih, LIU Wen-fung. 基于光纤布拉格光栅和压电转换器的电功率传感器[J]. 光学精密工程, 2011,19(9): 2255-2262

CHENG Chin-hsing, CHANG Min-chih, LIU Wen-fung. Electrical power sensor based on fiber Bragg grating and piezo-electric transducer[J]. Editorial Office of Optics and Precision Engineering, 2011,19(9): 2255-2262
CHENG Chin-hsing, CHANG Min-chih, LIU Wen-fung. 基于光纤布拉格光栅和压电转换器的电功率传感器[J]. 光学精密工程, 2011,19(9): 2255-2262 DOI： 10.3788/OPE.20111909.2255.

CHENG Chin-hsing, CHANG Min-chih, LIU Wen-fung. Electrical power sensor based on fiber Bragg grating and piezo-electric transducer[J]. Editorial Office of Optics and Precision Engineering, 2011,19(9): 2255-2262 DOI： 10.3788/OPE.20111909.2255.

摘要

针对传统功率计测量电功率存在线圈电感、电容与金属部分的涡流感应等限制

本文基于布拉格光纤光栅与压电转换器设计了电功率传感器来测量实功率与虚功率。将布拉格光纤光栅粘贴于压电转换器上

构建了动态应变模拟装置。负载电压与负载电流的乘积形成的等效电压施加在压电转换器上使布拉格光纤光栅动态变化

由此测量光栅动态变化所造成的波长改变量即可得到等效负载功率。相位检测电路用于测量负载电压与负载电流的相位差

由该相位差即可求得功率因数。所研究的传感器可以取代传统功率计用于实功率和虚功率的测量。

Abstract

The measurement of power by conventional meters has some limitations due to the inductance and capacitance of coils and the eddy current induction in the metal parts of the meters. Optical fiber gratings are currently being used as sensors for a number of physical quantities such as temperature

strain and pressure; other quantities

such as current and electrical power measurements can be detected by fiber gratings using appropriate transducers. This paper demonstrates an optical fiber sensor using a Fiber Bragg Grating (FBG) and a piezo-electrical transducer (PZT) to measure real and reactive powers. Mounting an FBG on a PZT bar

a dynamic strain simulator is constructed. The voltage equivalent to the product of load voltage and load current applied on PZT is converted to the dynamic variation of the FBG Bragg wavelength. The load power will be achieved by measuring the changing value of the wavelength. A phase detector circuit is used to measure the phase angle between voltage and current signals. The power factor can be obtained from the phase angle. Thus

the sensor can be used to measure real and reactive powers without the use of a traditional power meter.

关键词

Keywords

references

YOON W K, DEVANEY M J. Reactive power measurement using the wavelet transform [J]. IEEE Transactions on Instrumentation and Measurement, 2000,49:246-252.[2] SARKAR A, SENGUPTA S. A low-cost fault-tolerant real, reactive, and apparent power measurement technique using microprocessor [J]. IEEE Transactions on Instrumentation and Measurement, 2007, 56:2672-2680. [3] HILL K O, MELTZ G. Fiber Bragg grating technology fundamentals and overview [J]. J. Lightwave Technol., 1997,15:1263-1276. [4] KERSEY A D, DAVIS M A, PATRICK H J, et al.. Fiber grating sensors [J]. J. Lightwave Technol., 1997,15:1442-1463.[5] CHENG C H, CHEN M H, LIU W F, Measurement of AC current using a superstructure fiber grating [J]. Microwave and Optical Technology Letters, 2008, 50:1168-1171.[6] CHENG C H, LIN L M, LIU W F. Measurement of electric power using an optical fiber grating [J]. Microwave and Optical Technology Letters,2009,51(10):2438-2441.[7] JUNG J, NAM H, LEE J H, et al.. Simultaneous measurement of strain and temperature by use of a single-fiber Bragg grating and an erbium-doped fiber amplifier [J]. Appl. Opt., 1999,38(13):2749-2751.[8] JAMES S W, DOCKNEY M L, TATAM R P. Simultaneous independent temperature and strain measurement using in-fiber Bragg grating sensors [J]. Electron. Lett., 1996, 32:1133-1134.[9] PATRICK H J, WILLIAMS G M, KERSEY A D, et al.. Hybrid fiber Bragg grating/long period fiber grating sensor for strain/temperature discrimination [J]. IEEE Photon. Technol. Lett., 1996,8(9):1223-1225.[10] DU W C, TAO X M, TAM H Y. Fiber Bragg grating cavity sensor for simultaneous measurement of strain and temperature [J]. IEEE Photon. Technol. Lett., 1999, 11(1): 105-107.[11] GUAN B O, TAM H Y, TAO X M, et al.. Simultaneous strain and temperature measurement using a superstructure fiber Bragg grating [J]. IEEE Photo. Technol. Lett., 2000,12(6):675-677. [12] LOSS P V A, LAMEGO M M, SOUSA G C D, et al.. A single phase microcontroller based energy meter. IEEE Instrumentation and Measurement Technology Conference, 1998:797-800.[13] KANG L H, KIM D K, HAN J H. Estimation of dynamic structural displacements using fiber Bragg grating strain sensors [J]. Journal of Sound and Vibration, 2007,305:534-542.[14] YAO Y, YI B. FBG based voltage measurement using PZT modulation. International Conference on wireless communications, Networking, and Mobile Computing, WiCOM 2006.[15] CHENG C H, LAI L H, LIU W F. Noise sensor based on a Fiber Bragg Grating and a Piezo-electric Transducer [J]. Microwave and Optical Technology Letters,2011,53(4):958-961.

浏览量

687

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

5 MN光纤布拉格光栅力值传感器

胶黏剂黏弹性对粘贴式FBG应变传递的影响