光电经纬仪CCD曝光中心测量系统的设计

李满良; 吴钦章

doi:10.3788/OPE.20132105.1304

您当前的位置：

首页 >

文章列表页 >

光电经纬仪CCD曝光中心测量系统的设计

信息科学 | 更新时间：2020-08-12

- 光电经纬仪CCD曝光中心测量系统的设计
- CCD exposure center measuring system for photoelectric theodolite
- 光学精密工程 2013年21卷第5期页码：1304-1311
- 作者机构：
  
  中国科学院光电技术研究所
- 作者简介：
- 基金信息：
  
  国家863高技术项目()
- DOI：10.3788/OPE.20132105.1304
  中图分类号： V556.5
- 收稿日期：2012-11-13，
  
  修回日期：2013-01-28，
  
  网络出版日期：2013-05-24，
  
  纸质出版日期：2013-05-15
- 稿件说明：
移动端阅览
李满良吴钦章. 光电经纬仪CCD曝光中心测量系统的设计[J]. 光学精密工程, 2013,21(5): 1304-1311

LI Man-Liang WU Qin-zhang. CCD exposure center measuring system for photoelectric theodolite[J]. Editorial Office of Optics and Precision Engineering, 2013,21(5): 1304-1311
李满良吴钦章. 光电经纬仪CCD曝光中心测量系统的设计[J]. 光学精密工程, 2013,21(5): 1304-1311 DOI： 10.3788/OPE.20132105.1304.

LI Man-Liang WU Qin-zhang. CCD exposure center measuring system for photoelectric theodolite[J]. Editorial Office of Optics and Precision Engineering, 2013,21(5): 1304-1311 DOI： 10.3788/OPE.20132105.1304.

摘要

根据高精度靶场测角要求，设计了一套以IRIG-B码终端为时间基准，基于数字信号处理器（DSP）和现场可编程门阵列（FPGA）的CCD曝光中心测量系统。首先给出了CCD曝光中心的测量原理及硬件组成，利用共源的两台IRIG-B码终端控制发光二极管和CCD探测器，通过调整B码终端输出信号时延控制发光二极管，得到了1 Hz脉冲前后沿和曝光脉冲前后沿对齐的2个关键时刻。针对人工图像判读精度低的问题，提出了利用图像重心的提取算法和改进的Krisch边缘算法，自动计算得到CCD曝光中心，其精度优于17 s。在外场对多套光电经纬仪CCD曝光中心进行了测量，并将测量结果应用到外场校飞数据处理中，结果表明，在飞机过航捷时光电经纬仪的测角误差平均减少了55%。该系统稳定、可靠，在靶场测量中有着广泛的应用前景。

Abstract

According to the demands of a photoelectric theodolite for angle measurement accuracy

a CCD exposure center measurement system by taking the IRIG-B code terminal as time reference was designed based on a Digital Signal Processor(DSP) and a Field Programmable Gate Array(FPGA). The measuring principle and hardware components of the CCD exposure center were given. Then two sets of IRIG-B terminals with a total source code were used to control a light emitting diode and a CCD detector. By adjusting the B code terminal output signal time delay to control the light-emitting diode

two key moments along with the front and back edges for 1 Hz pulses and the exposure pulses were obtained

respectively. Aiming at the low accuracy of artificial image interpretation

an image edge extraction algorithm based on the image centre and an improved Krisch algorithm were proposed

and the CCD exposure center with a precision better than 17 s was automatically calculated. Finally

several sets of CCD exposure centers for photoelectric theodolites were measured in the field

and the measurement results were applied to the outfield calibration flight data processing. Obtained results show that the angle measuring error of photoelectric theodolite is reduced by 55% on average in the Czech Airlines time

and the system is stable

reliable and has a wider application prospect.

关键词

Keywords

references

王宗友，付承毓，王芳. 基于数据配准提高光电经纬仪的测量精度 \[J\]. 中国光学与应用光学，2010，3(6):586-590.WANG Z Y,FU C M,WANG F. Measurement accuracy of photoelectric theodolite based on data alignment \[J\]. Chinese Optics and Applied Optics, 2010，3(6):586-590.(in Chinese)[2]薛向尧，高云国，韩光宇，等. 水平式经纬仪指向误差的统一补偿技术 \[J\]. 光学精密工程, 2011, 19(7): 1524-1530.XUE X Y, GAO Y G, HAN G Y, et al.. Total correction method of pointing error for level mounting theodolite \[J\]. Opt. Precision Eng., 2011, 19(7): 1524-1530. (in Chinese)[3]李春芳. 振动及曝光时间对全息照相实验的影响 \[J\]. 实验科学与技术，2012，10(2):18-20.LI CH F. Impact of vibrations and exposure time on the hologram experiment \[J\]. Experiment Science and Technology, 2012，10(2):18-20. (in Chinese)[4]韩雪冰，张景旭，赵金宇，等.水平式光电望远镜目标定位误差的预测 \[J\] . 光学精密工程, 2010, 18(7)： 1595-1604.HAN X B, ZHANG J X, ZHAO J Y, et al.. Forecast for orientation errors of alt-alt photoelectric telescope \[J\]. Opt. Precision Eng., 2010, 18(7)： 1595-1604. (in Chinese)[5]张传胜. 基于FPGA/SOPG架构的面阵CCD图像采集系统的设计 \[J\] . 液晶与显示, 2011, 26(5) : 636-639.ZHANG CH SH. Design of image acquisition system based on array CCD with FPGA/SOPC architecture \[J\]. Liquid Crystals and Displays, 2011, 26(5): 636-639. (in Chinese)[6]张贵祥, 金光, 郑亮亮，等. 高速多通道CCD图像数据处理与传输系统设计 \[J\] . 液晶与显示, 2011, 26(3) :397-403.ZHANG G X,JIN G,ZHENG L L , et al.. Design of high-speed and multi-ghannel CCD image data processing and transmission system \[J\]. Liquid Crystals and Displays,2011,26(3): 397-403. (in Chinese)[6]杨利红, 李新娥, 李国宁,等. 基于图像采集卡的图像显示与处理软件开发 \[J\]. 液晶与显示, 2010, 25(6): 909-913.YANG L H, LI X E,LI G N, et al.. Development of image displaying and processing software based on image grabbing card \[J\]. Liquid Crystals and Displays, 2010,25(6): 909-913. (in Chinese)[7]陈伦海，黄君凯，杨帆，等. 基于FPGA的实时边缘检测系统 \[J\]. 液晶与显示, 2011, 26(2): 200-204.CHEN L H. HUANG J K,YANG F, et al.. Real-time edge detection system based on FPGA \[J\]. Liquid Crystals and Displays, 2011,26(2): 200-204. (in Chinese)[8]LI Y， QIAO Y F， SU W X，LIU Z X. Double-theodolite measurement system used in the image calibration of space photographic instrument[J]. Opto-electronics Letters, 2005，1(3):213-216.[9]陈非，敬忠良. 空基多平台多传感器时间空间数据配准与目标跟踪 \[J\]. 控制与决策, 2001，16(B11): 808-811,821. CHENG F, JING Z L. Time and spatial registration and target tracking for multiple airborne mobile platforms and sensors \[J\]. Control and Decision, 2001，16(B11): 808-811,821. (in Chinese)[10]邴志光，束坤，顾燕飞. IRIG-B码在时间同步系统中的应用 \[J\]. 现代电子技术, 2012，35(7):16-18. BIN Z G, SHU K, GU Y F. Application of IRIG-B code in time synchronization system \[J\]. Modern Electronic Technique, 2012，35(7):16-18. (in Chinese)

浏览量

195

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

靶场适用的光电经纬仪光轴平行性检测

基于SURF特征描述符和杰卡德距离的文物碎片拼接

低预紧扭矩螺栓连接悬臂梁的2倍谐振响应

961单元自适应光学系统波前处理器

声光可调谐滤波成像光谱仪的CCD成像电子学系统