埋入式光纤布拉格光栅传感器封装结构对测量应变的影响

吴入军; 郑百林; 贺鹏飞; 谭跃刚

doi:10.3788/OPE.20142201.0024

您当前的位置：

首页 >

文章列表页 >

埋入式光纤布拉格光栅传感器封装结构对测量应变的影响

现代应用光学 | 更新时间：2020-08-13

- 埋入式光纤布拉格光栅传感器封装结构对测量应变的影响
- Influence of encapsulation structures for embedded fiber-optic Bragg grating sensors on strain measurement
- 光学精密工程 2014年22卷第1期页码：24-30
- 作者机构：
  
  1. 同济大学航空航天与力学学院上海,200092
  2. #br# 2.武汉理工大学机电工程学院,湖北武汉,430070
- 作者简介：
- 基金信息：
  
  国家863高技术研究发展计划资助项目(No.2012AA040106)()
- DOI：10.3788/OPE.20142201.0024
  中图分类号： TN253
- 收稿日期：2013-05-20，
  
  纸质出版日期：2014-01-15
- 稿件说明：
移动端阅览
吴入军, 郑百林, 贺鹏飞等. 埋入式光纤布拉格光栅传感器封装结构对测量应变的影响[J]. 光学精密工程, 2014,22(1): 24-30

WU Ru-jun, ZHENG Bai-lin, HE Peng-fei etc. Influence of encapsulation structures for embedded fiber-optic Bragg grating sensors on strain measurement[J]. Editorial Office of Optics and Precision Engineering, 2014,22(1): 24-30
吴入军, 郑百林, 贺鹏飞等. 埋入式光纤布拉格光栅传感器封装结构对测量应变的影响[J]. 光学精密工程, 2014,22(1): 24-30 DOI： 10.3788/OPE.20142201.0024.

WU Ru-jun, ZHENG Bai-lin, HE Peng-fei etc. Influence of encapsulation structures for embedded fiber-optic Bragg grating sensors on strain measurement[J]. Editorial Office of Optics and Precision Engineering, 2014,22(1): 24-30 DOI： 10.3788/OPE.20142201.0024.

摘要

考虑在实际应变测量中传感器封装形式会影响光纤Bragg光栅测得的应变响应

本文研究了测量应变与实际应变之间的关系。针对埋入式光纤Bragg光栅传感器

建立了应变传递函数

并对传递函数的正确性和各个参数对测量应变的影响进行了研究。首先

根据埋入式光纤Bragg光栅传感器的受力特点

提出了多项式形式的剪应力分布

进一步建立了应变传递函数。然后

利用数值方法和实验对该应变传递函数进行验证。最后

分析了传感器长度、胶结层弹性模量、胶结层厚度对测量应变的影响。计算结果表明:该应变传递函数正确;胶结层厚度越薄

弹性模量越大

越有利于应变传递。该应变传递函数计算误差控制在5%以内

完全满足埋入式光纤Bragg光栅测量精度要求

对其实际应用具有指导意义。

Abstract

As the package structures of a sensor seriously interfere the strain responses measured by a Fiber-optic Bragg Grating(FBG)

this paper focuses on the relationship of measured strain and true strain in the actual measurement. It establishes a strain transfer function for embedded FBG sensors and verifies the validity of the transfer function and the influence of different parameters on the measured strain. Firstly

based on mechanical characteristics of embedded FBG sensors

the shear stress distribution with a form of polynomial is presented

then the strain transfer function is established and verified by taking a numerical method and an experiment. Finally the influence of sensor length

cementation layer modulus and cementation layer thickness on the measured strain is analyzed. Experimental results indicate that the strain transfer function is valid. Moreover

the thinner the cementation thickness and the higner the cementation modulus are

the more convenient the strain transfer is. The strain transfer function satisfies the accuracy requirement of embedded FBG sensors because the calculation error is controlled within 5%

which is considered as a guidance for its practical application.

关键词

Keywords

references

吴朝霞, 吴飞. 光纤光栅传感器原理及应用[M]. 北京:国防工业出版社, 2011.

WU ZH X, WU F. Fiber-optic Grating Sensors Theory and Application[M]. Beijing: National Defence Industry Press, 2011.(in Chinese)

张自嘉. 光纤光栅理论基础与传感技术[M]. 北京:科学出版社, 2009.

ZHANG Z J. Optic Fiber Grating Theoretical Basis and Sensing Technology[M]. Beijing: Science Press, 2009. (in Chinese)

FARHAD A, YUAN L B. Mechanics of bond and interface shear transfer in optical fiber sensors[J]. Journal of Engineering Mechanics, 1998, 124(4):385-394.

周智, 李冀龙, 欧进萍. 埋入式光纤光栅界面应变传递机理与误差修正[J]. 哈尔滨工业大学学报, 2006, 38(1):49-55.

ZHOU ZH, LI J L, OU J P. Interface strain transfer mechanism and error modification of embedded FBG strain sensors [J]. Journal of Harbin Institute of Technology, 2006, 38(1):49-55. (in Chinese)

李东升, 李宏男. 埋入式封装的光纤光栅传感器应变传递分析[J]. 力学学报, 2005, 37(4):435-441.

LI D SH, LI H N. Strain transferring analysis of embedded fiber Bragg grating sensors[J]. Chinese Journal of Theoretical and Applied Mechanic. 2005, 37(4):435-441. (in Chinese)

梁德志, 孙丽, 黄昌铁, 等. 埋人式FBG传感器应变传递的有限元计算与理论分析比较[J]. 沈阳建筑大学学报, 2008, 24(1):72-76.

LIANG D ZH, SUN L, HUANG CH T, et al.. Comparison of strain transfer of embedded FBG sensors calculated by FEM and theory formula [J]. Journal of Shenyang Architectural University, 2008, 24(1):72-76. (in Chinese)

常新龙, 李明, 谷小飞. 基于线粘弹性的埋入式聚合物光纤传感器应变传递研究[J]. 固体火箭技术, 2010, 33(3):353-359.

CHANG X L, LI M, GU X F. Study on strain transfer of embedded polymer fiber-optic sensors based on viscoelasticity theory[J]. Journal of Solid Rocket Technology, 2010, 33(3):353-359.(in Chinese)

郭伟, 李新良, 宋昊. 表面粘帖式光纤光栅传感器的应变传递分析[J]. 计测技术, 2011, 31(4):1-3.

GUO W, LI X L, SONG H. Strain transfer analysis of surface pasted optical fiber grating sensors[J]. Metrology & Measurement Technology. 2011, 31(4):1-3.(in Chinese)

丘野. 表面粘帖式FBG传感器应变传递机制研究[D]. 上海:上海交通大学, 2012.

QIU Y. Strain Transfer Study of Surface Pasted FBG Sensors[D].Shanghai: Shanghai Jiaotong University , 2012. (in Chinese)

吴俊, 陈伟民, 章鹏, 等. 粘接层弹性模量对FBG传感器应变传递性能的影响[J]. 光学精密工程, 2011, 19(12):2941-2946.

WU J, CHEN W M, ZHANG P, et al.. Strain transfer influence of binding layer modulus on fiber-optic Bragg grating sensors[J]. Opt. Precision Eng., 2011, 19(12):2941-2946. (in Chinese)

吴永红, 邵长江, 屈文俊, 等. 光纤光栅应变传感器光力转换的非线性时变方程[J]. 同济学报:自然科学, 2011, 39(1):53-56.

WU Y H, SHAO CH J, QU W J, et al.. Nonlinear time-dependent equation of light-force transition of fiber-optic grating strain sensors[J]. Journal of TongJi University (Natural Science), 2011, 39(1): 53-56. (in Chinese)

周建华. 光纤光栅传感器应变传递特性分析[D]. 武汉:武汉理工大学, 2010.

ZHOU J H. Strain Transfer Characteristic of Fiber Bragg Grating Sensors[D]. Wu Han: Wuhan University of Technology, 2010. (in Chinese)

吴永红, 屈文俊, 邵长江, 等. 光纤光栅应变传感器光力转换的理论方程[J]. 光学学报, 2009, 29(8):2067-2070.

WU Y H, QU W J, SHAO CH J, et al.. Basic optical-mechanical transformation theoretical equation for FBG strain sensor[J]. Acta Optica Sinica, 2009, 29(8):2067-2070. (in Chinese)

浏览量

133

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

相衬光学相干层析的薄膜全场力学测量方法

相衬光学相干弹性成像的超分辨应变测量

粘贴于薄板表面的光纤布拉格光栅应变传感器误差修正

受弯件上粘贴型光纤布拉格光栅的应变传递规律

高功率半导体激光器列阵封装引入应变的测量