压电驱动器的开闭环迭代学习控制

李朋志; 闫丰; 葛川; 李佩玥; 隋永新; 杨怀江

doi:10.3788/OPE.20142202.0414

您当前的位置：

首页 >

文章列表页 >

压电驱动器的开闭环迭代学习控制

微纳技术与精密机械 | 更新时间：2020-08-13

- 压电驱动器的开闭环迭代学习控制
- Open-closed loop iterative learning control of piezoelectric actuators
- 光学精密工程 2014年22卷第2期页码：414-419
- 作者机构：
  
  中国科学院长春光学精密机械与物理研究所应用光学国家重点实验室,吉林长春,130033
- 作者简介：
- 基金信息：
- DOI：10.3788/OPE.20142202.0414
  中图分类号： TP273.1;TN384
- 收稿日期：2013-10-11，
  
  纸质出版日期：2014-02-20
- 稿件说明：
移动端阅览
李朋志,闫丰,葛川等. 压电驱动器的开闭环迭代学习控制[J]. 光学精密工程, 2014,22(2): 414-419

LI Peng-zhi, YAN Feng, GE Chuan etc. Open-closed loop iterative learning control of piezoelectric actuators[J]. Editorial Office of Optics and Precision Engineering, 2014,22(2): 414-419
李朋志,闫丰,葛川等. 压电驱动器的开闭环迭代学习控制[J]. 光学精密工程, 2014,22(2): 414-419 DOI： 10.3788/OPE.20142202.0414.

LI Peng-zhi, YAN Feng, GE Chuan etc. Open-closed loop iterative learning control of piezoelectric actuators[J]. Editorial Office of Optics and Precision Engineering, 2014,22(2): 414-419 DOI： 10.3788/OPE.20142202.0414.

摘要

由于开闭环迭代学习控制方法能在加快收敛速度的情况下降低跟踪误差

本文利用该控制方法来提高压电驱动器(PZT)的高频轨迹跟踪精度。首先

提出了离散时间下的开环P型结合闭环PI型的迭代学习律

并且给出了基于该学习律的收敛性条件。然后

设计了用于PZT系统的离散开闭环迭代学习控制器。最后

针对50 Hz单频和25 Hz+50 Hz复频三角波轨迹进行了跟踪控制实验。实验结果表明:所提出的迭代学习控制器对上述2种轨迹的最大跟踪误差分别为10.6 nm和12.5 nm

相对于PID控制器

分别降低了96.25%和95.62%。结果显示:提出的控制方法易于实现

无需准确的PZT迟滞和系统模型就可以获得很高的跟踪精度

能有效地满足高频和复频轨迹跟踪的精度要求。

Abstract

As open-closed loop iterative learning control scheme can up the convergence and reduce the tracking error

this paper uses the scheme to improve high frequency trajectory tracking accuracy of a piezoelectric actuator(PZT). First

a discrete-time open-loop P-type with closed-loop PI-type iterative learning law was proposed and its convergence condition was given. Then

a discrete-time open-closed loop iterative learning controller was designed for the PZT system. Finally

as to 50 Hz and 25Hz+50Hz triangular desired trajectories with single and compound frequencies

the tracking control experiment was performed. Experimental results indicate that the proposed iterative learning controller can achieve 10.6 nm and 12.5 nm maximum tracking errors for the 2 kinds of trajectories

which are 96.25% and 95.62% less than that of the PID controller. It concludes that the proposed control scheme can be easily implemented and can obtain the high accuracy of trajectory tracking without precise hysteresis and PZT system models. It meets both the requirements of single and compound frequency trajectory tracking for high tracking accuracy.

关键词

Keywords

references

孙立宁, 孙绍云, 曲东升, 等. 基于PZT的微驱动定位系统及控制方法的研究[J].光学精密工程,2004,12(1): 55-59.

SUN L N, SUN SH Y, QU D SH , et al.. Micro-drive positioning system based on PZT and its control [J]. Opt. Precision Eng., 2004, 12(1): 55-59. (in Chinese)

贾宏光,郑岩,吴一辉,等.非线性模型的压电元件复合控制方法[J].光学精密工程,2007,15(10): 1547-1552.

JIA H G, ZHENG Y, WU Y H, et al.. PZT actuator control complex arithmetic based on nonlinear model [J]. Opt. Precision Eng., 2007, 15(10):1547-1552. (in Chinese)

YONG Y K, APHALE S, MOHEIMANI S O R. Design, identification, and control of a flexure-based XY stage for fast nanoscale positioning [J]. IEEE Transactions on Nanotechnology, 2009, 8(1): 46-54.

LI Y M, XU Q S. Development and assessment of a novel decoupled XY parallel micropositioning platform [J]. IEEE/ASME Transactions on Mechatronics, 2010, 15(1): 125-135.

ZHANG X L, TAN Y H, SU M Y, et al..Neural networks based identification and compensation of rate-dependent hysteresis in piezoelectric actuators [J]. Physica B, 2010, 405: 2687-2693.

LI P Z, GU G Y, LAI L J, et al.. Hysteresis modeling of piezoelectric actuators using the fuzzy system [C]. The 3rd International Conference on Intelligent Robotics and Applications,LNAI, 2010, 6424(1): 114-124.

赖志林, 刘向东, 耿洁, 等. 压电陶瓷执行器迟滞的滑模逆补偿控制[J].光学精密工程,2011,19(6): 1281-1290.

LAI ZH L, LIU X D, GENG J, et al.. Sliding mode control of hysteresis of piezoceramic actuator based on inverse Preisach compensation [J]. Opt. Precision Eng., 2011, 19(6): 1281-1290. (in Chinese)

ARIMOTO S, KAWAMURA F, MIYAZAKI F. Bettering operation of robots by learning [J]. Journal of Robotic Systems, 1984, 1(2): 123-140.

皮道映, 孙优贤. 非线性时变系统开闭环P型迭代学习控制的收敛性[J].自动化学报,1999,25(3): 351-354.

PI D Y, SUN Y X. The convergence of iterative learning control with open-closed-loop P-type scheme for nonlinear time-varying systems [J]. Acta Automatica Sinica, 1999, 25(3): 351-354. (in Chinese)

皮道映, 孙优贤. 离散非线性系统开闭环P型迭代学习控制律及其收敛性[J].控制理论与应用,1997,14(2): 157-161.

PI D Y, SUN Y X. On the convergence of open-closed-loop P-type iterative learning control scheme for nonlinear discrete systems [J]. Control Theory and Applications, 1997,14(2): 157-161. (in Chinese)

于少娟, 冯冬梅, 吴聚华. 2-D系统理论在开闭环迭代学习控制中的应用[J].仪器仪表学报,2002,23(3): 402-404.

YU SH J, FENG D M, WU J H. Application of 2-D system theory in the design of open-closed-loop iterative learning control [J]. Chinese Journal of Scientific Instrument, 2002, 23(3): 402-404. (in Chinese)

魏燕定,黄金永,董春兵. 基于ILC 的压电微位移驱动器电源线性化研究[J].仪器仪表学报,2004,25(5): 570-573.

WEI Y D, HUANG J Y, DONG CH B. Linearization of supply power to piezoelectric actuator based on iterative learning control [J]. Chinese Journal of Scientific Instrument, 2004, 25(5): 570-573. (in Chinese)

浏览量

572

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

应变式微型精密压电驱动器的一体化设计及其PID控制

三自由度压电偏摆台耦合迟滞模型建模与逆补偿

多延时输入下压电驱动器迟滞建模及实验验证

基于平行度误差补偿的多通道双晶单色器运动控制

压电驱动器迟滞非线性的分数阶建模及实验验证