全光纤激光器光束质量的优化

董繁龙; 赵方舟; 葛廷武; 王智勇

doi:10.3788/OPE.20142204.0844

您当前的位置：

首页 >

文章列表页 >

全光纤激光器光束质量的优化

现代应用光学 | 更新时间：2020-08-13

- 全光纤激光器光束质量的优化
- Optimization of beam quality for all-fiber lasers
- 光学精密工程 2014年22卷第4期页码：844-849
- 作者机构：
  
  北京工业大学激光工程研究院国家产学研激光技术中心北京,100124
- 作者简介：
- 基金信息：
  
  国家科技重大专项资助项目（No.2010ZX04013-052）();科研基地-科技创新平台-光纤激光器研究平台资助项目（No.PXM2011_014204_09_00
- DOI：10.3788/OPE.20142204.0844
  中图分类号： TN248.1
- 收稿日期：2013-06-26，
  
  修回日期：2013-08-25，
  
  纸质出版日期：2014-04-25
- 稿件说明：
移动端阅览
董繁龙, 赵方舟, 葛廷武等. 全光纤激光器光束质量的优化[J]. 光学精密工程, 2014,22(4): 844-849

DONG Fan-long, ZHAO Fang-zhou, GE Ting-wu etc. Optimization of beam quality for all-fiber lasers[J]. Editorial Office of Optics and Precision Engineering, 2014,22(4): 844-849
董繁龙, 赵方舟, 葛廷武等. 全光纤激光器光束质量的优化[J]. 光学精密工程, 2014,22(4): 844-849 DOI： 10.3788/OPE.20142204.0844.

DONG Fan-long, ZHAO Fang-zhou, GE Ting-wu etc. Optimization of beam quality for all-fiber lasers[J]. Editorial Office of Optics and Precision Engineering, 2014,22(4): 844-849 DOI： 10.3788/OPE.20142204.0844.

摘要

基于激光器的结构，实验研究了影响光束质量的因素。搭建了百瓦级全光纤激光器，在最大泵浦功率为436 W的条件下，在1 080 nm处获得的激光输出为300 W，光-光转换效率为69%，光束质量

为1.13。实验研究了谐振腔出射的激光光束在传能光纤中传输时径向功率分布的变化，结果显示：随着光束在光纤中传输距离的增加，光纤中的包层光功率呈现出先增加后保持不变的趋势，因而在传输距离上选择不同的长度对包层光进行剥除，可以获得不同的光束质量。实验还显示，在相同的泵浦条件下，与包层光剥离器设置在腔外相比，其设置在谐振腔内可获得更高的激光输出功率，但是光束质量较差。最后，采用在腔内腔外各加一个包层光剥离器的方法获得了更好的光束质量，此时

为1.07。

Abstract

On the basis of laser structures

factors affecting on the beam quality were experimentally explored to improve the beam quality of fiber lasers. A hundred-watts class all-fiber laser with an output power of 300 W at 1 080 nm was built when the maximum pump power was 436 W. The beam quality(

) was tested

and experiments show that the

is 1.13 and optical-optical conversion efficiency is 69%. Then

the change of the radial power distribution of the laser beam that transported in a fiber was experimentally analyzed. The result shows that the cladding light power increases initially and remains constant afterwards as the transmission distance of laser beam increases in the fiber. Therefore

different beam qualities can be obtained after stripping the cladding light at any selected transmission distance. In addition

the higher laser output power can be obtained when the cladding light stripper is set inside instead of outside of the cavity under the same pumping conditions. However

a worse beam quality is left in this case. Finally

a better beam quality

at 1.07 is obtained by setting two cladding light strippers outside and insider the cavity

respectively.

关键词

Keywords

references

郝明明, 秦莉, 朱洪波, 等. 基于半导体激光短阵列的976nm高功率光纤耦合模块[J]. 光学精密工程, 2013, 21(4):895-903. HAO M M, QIN L, ZHU H B, et al. High power 976nm fiber coupled module based on diode laser short bars[J]. Opt. and Precision Eng., 2013, 21(4):895-903.(in Chinese)

LIMPERT J, LIEM A, ZELLMER H, et al.. 500 W continuous-wave fiber laser with excellent beam quality[J]. Electron. Lett., 2003, 39(8):645-647.

LIU C H, EHLERS B, DOERFEL F, et al. 810 W continuous-wave and single-transverse-mode fibre laser using 20 μm core Yb-doped double-clad fibre[J]. Electronics Letters, 2004, 40(23):1471-1472.

JEONG Y, SAHU J K, PAYNE D N, et al.. Ytterbium-doped large-core fiber laser with 1.36 kW continuous-wave output power[J]. Opt. Exp., 2004, 12(25):6088-6092.

LIMPERT J, ROSER F, KLINGEBIEL S, et al.. The rising power of fiber lasers and amplifiers[J]. IEEE J. Sel. Top. Quantum Electron., 2007, 13(3):537-545.

LI H X, CHYR I, JIN X, et al. >700 W continuous-wave output power from single laser diode bar[J]. Electronics Letters, 2007, 43(1):27-29.

GAPONTSEV V, GAPONTSEV D, PLATONOV N, et al. 2 kW CW ytterbium fiber laser with record diffraction-limited brightness[C]. Lasers and Electro-Optics Europe, CLEO/Europe, 2005 Conference on IEEE, 2005:508.

IPG Photonics Corporation, IPG Photonics successfully tests world's first 10 kilowatt single-mode production laser[EB/OL]. http://www.ipgbeijing.com/Collateral/Documents/English-US/Summer_Newsletter_IPG_2009.pdf.

段开掠, 赵保银, 赵卫, 等. 1000 W全光纤激光器[J]. 中国激光, 2009, 36(12):3219. DUAN K L, ZHAO B Y, ZHAO W, et al. 1000 W all-fiber laser[J]. Chinese Journal of Lasers, 2009, 36(12):3219. (in Chinese)

马阎星, 肖虎, 周朴, 等. 全光纤激光器实现千瓦级功率输出[J]. 强激光与粒子束, 2011, 23(5):1137 -1138. MA Y X, XIAO H, ZHOU P, et al. kW level fiber laser in all fiber format[J]. High Power Laser and Particle Beams, 2011, 23(5):1137-1138.(in Chinese)

张利明, 周寿桓, 赵鸿, 等. 1 kW全光纤激光器实验研究[J]. 激光与红外, 2012, 42(10):1127-1130. ZHANG L M, ZHOU SH H, ZHAO H, et al. Experiment research of 1 kW all fiber laser[J]. Laser & Infrared, 2012, 42(10):1127-1130.(in Chinese)

GLOGE D. Weakly guiding fibers[J]. Appl. Opt., 1971, 10(10):2252-2258.

MCLANDRICH M N. Core dopant profiles in weakly fused single mode fibers[J]. Electron. Lett., 1988, 24(1): 8-10.

SHIRAISHI K, AIZAWA Y, KAWAKAMI S. Beam-expanding fiber using thermal diffusion of the dopant[J]. Lightwave Technol., 1990, 8(8):1151-1161.

廖素英. 大模场光纤模场大小提升能力分析[J]. 激光与光电子学进展, 2010, 47(12):120602. LIAO S Y. Analysis of mode scalability in large mode area fibers[J]. Laser & Optoelectronics Progress, 2010, 47(12):120602.(in Chinese)

浏览量

250

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

受激布里渊散射自调Q产生高功率白光超连续谱

基于对称双模耦合器的波长可切换柱矢量光纤激光器

皮秒脉冲近红外超连续谱激光器

基于LCP径向偏振光输出的掺镱MOPA脉冲光纤激光器

高功率全光纤侧面抽运耦合器研究进展