高量程加速度计动态线性校准系统

石云波; 杨志才; 曹慧亮; 智丹; 陈艳香; 王艳阳

doi:10.3788/OPE.20162402.0381

您当前的位置：

首页 >

文章列表页 >

高量程加速度计动态线性校准系统

微纳技术与精密机械 | 更新时间：2020-08-13

- 高量程加速度计动态线性校准系统
- Dynamic linearity calibration system for accelerometers with high measurement range
- 光学精密工程 2016年24卷第2期页码：381-389
- 作者机构：
  
  1. 中北大学电子测试技术国防科技重点实验室,山西太原,030051
  2. 中北大学仪器与电子学院, 山西太原 030051
- 作者简介：
- 基金信息：
  
  国家杰出青年科学基金资助项目(No.51225504)();国家安全重大基础研究计划(973)资助项目(No.2012CB723404)()
- DOI：10.3788/OPE.20162402.0381
  中图分类号： TH824.4
- 收稿日期：2015-07-20，
  
  修回日期：2015-08-21，
  
  纸质出版日期：2016-02-25
- 稿件说明：
移动端阅览
石云波, 杨志才, 曹慧亮等. 高量程加速度计动态线性校准系统[J]. 光学精密工程, 2016,24(2): 381-389

SHI Yun-bo, YANG Zhi-cai, CAO Hui-liang etc. Dynamic linearity calibration system for accelerometers with high measurement range[J]. Editorial Office of Optics and Precision Engineering, 2016,24(2): 381-389
石云波, 杨志才, 曹慧亮等. 高量程加速度计动态线性校准系统[J]. 光学精密工程, 2016,24(2): 381-389 DOI： 10.3788/OPE.20162402.0381.

SHI Yun-bo, YANG Zhi-cai, CAO Hui-liang etc. Dynamic linearity calibration system for accelerometers with high measurement range[J]. Editorial Office of Optics and Precision Engineering, 2016,24(2): 381-389 DOI： 10.3788/OPE.20162402.0381.

摘要

设计了双弹头霍普金森杆用于精确标定高

值加速度计的动态线性参数。基于一维应力波传播理论和弹性波叠加原理

分析了双弹头霍普金森杆为不同尺寸时对获取所需激励加速度信号的影响。利用ANSYS/LS-DYNA有限元仿真软件对不同设计条件下双弹头霍普金森杆的冲击效果进行了仿真分析。通过对不同影响因素的对比

确定了结构参数

设计了直径为30 mm

长度为1200 mm的双弹头霍普金森杆

即高量程加速度计动态线性校准系统。利用设计的双弹头霍普金森杆对高量程加速度计进行了动态线性校准和试验验证

结果显示加速度计动态线性误差在5%以内

证明了设计的装置可对高量程加速度计进行动态线性校准

校准结果基本满足冲击校准的要求。

Abstract

A dynamic linearity calibration system

dual warhead Hopkinson bar

was designed to calibrate the dynamic linear parameters of a micro accelerometer with high measurement range accurately. On the basis of one-dimension stress wave theory and elastic wave superposition principle

the influences of the dual warhead Hopkinson bar with different sizes on the required acceleration signals were analyzed. The ANSYS/LS-DYNA was employed to simulate the shock effect of the dual warhead Hopkinson bar under different design conditions. According to analysis and simulation on different factors

the design parameters were determined. Then

a dynamic linearity calibration system(dual warhead Hopkinson bar) for accelerometers with the diameter of 30 mm and the length of 1200 mm was designed. The dual warhead Hopkinson bar was used in the dynamic linearity calibration of an accelerometer with high measurement range. The results indicate that the dynamic linear error of the accelerometer is within 5%

which verifies that the dual warhead Hopkinson bar designed is feasible for dynamic linearity calibration of the accelerometers with higher measurement ranges

and the calibration results satisfy the requirements of shock calibration.

关键词

Keywords

references

张立杰,梁增友,马林. 钻地弹战斗部技术特点及发展趋势[J]. 机械,2012,04:1-5. ZHANG L J,LIANG Z Y,MA L.Technical characteristics and trends of development of earth penetrator warhead[J].Machinery,2012,04:1-5.(in Chinese)

刘妤,温志渝. 微加速度传感器的研究现状及发展趋势[J]. 光学精密工程,2004,3(12):81-86. LIU Y,WEN ZH Y. Researching Status and developing tendencyof micro accelerometer[J].Opt. Precision Eng.,2004,3(12):81-86.(in Chinese)

ANDREW R,ATWELL,ROBERT S.Simulation, fbrication and testing of bulk micromachined 6H-SiC high-g piezoresistive accelerometers[J]. Sensors and Actuators A,2003,104:11-18.

CAO H L,LI H SH.Investigation of avacuum packaged MEMS gyroscope architecture's temperature robustness[J].International Journal of Applied Electromagnetics and Mechanics,2013,41(4):495-506.

石云波,赵锐,唐军,等. 单片三轴大量程加速度传感器性能测试与分析[J]. 传感技术学报,2012,25(9):1236-1243. SHI Y B,ZHAO R,TANG J, et al..Testing and analysis of single-chip tri-axial high measure range MEMS accelerometer[J].Chinese Journal of Sensors and Actuators,2012,25(9):1236-1243.(in Chinese)

曹慧亮. 硅微机械陀螺仪静电补偿与控制技术研究和实验[D]. 南京:东南大学, 2014. CAO H L. Research and experiment on the technology of electrostatic compensation and control of silicon micro-machined gyroscope[D]. Nanjing:Southeast University, 2014.(in Chinese)

BRADFORD S D, TIM D, JINBO K. A Monolithic High-g SOI-MEMS Accelerometer for measuring Projectile Launch and Flight Accelerations[C].IEEE Sensors conference, Vienna, Autriche, 2004.

刘危,解旭辉,李圣怡. 微机械惯性传感器的技术现状及展望[J]. 光学精密工程, 2003, 11(5):425-429. LIU W,XIE X H,LI SH Y.Present state and perspectives of micro-machined inertial sensors[J].Opt. Precision Eng.,2003,11(5):425-429.(in Chinese)

李婉蓉,范锦彪,王燕,等. 基于小尺寸Hopkinson杆的动态校准系统[J]. 传感技术学报,2013,26(11):1617-1620. LI W R,FAN J B,WANG Y, et al..The dynamic calibration system based on micro-hopkinson bar[J].Chinese Journal of Sensors and Actuators,2013,26(11):1617-1620.(in Chinese)

IEC/SC47E.IEC 60747-14-4 Semiconductor devices-Part14-4:Semiconductor accelerometers[S].2011.

赵习金. 分离式霍普金森压杆实验技术的改进和应用[D]. 长沙:中国人民解放军国防科学技术大学,2003. ZHAO X J.Improvement and Application of SHPB technique[D]. Changsha:National University of Defense Techn-ology,2003.(in Chinese)

祁晓瑾. MEMS高g值加速度传感器研究[D].太原:中北大学,2007. QI X J.The Research on the MEMS High g Accelerometer[D].Taiyuan:North University of China,2007.(in Chinese)

浏览量

338

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

巨型科学可控反射镜缩比模型系统抖动检测

MEMS器件与电路共同仿真原型系统

测试压阻式三轴高g加速度计的霍普金森杆法

具有自检测功能的闭环加速度计接口电路设计

基于氧化锌纳米线的硅谐振式加速度计